Overhead Stirrers, Stirrers, Equipment
-
RW 28 Digital Overhead Stirrer
IKA WorksPowerful, mechanically controlled laboratory stirrer designed for highly viscous applications for quantities up to 80 l (H2O). It is suitable for intensive mixing for use in laboratories and pilot plants. The stirrer comes equipped with a protection for overheating of the motor by means of…
-
The ultimate in compact design measuring only two by four inches. The BDC250 offers great capabilities in a small package; used in formulation, R&D, clinical research, education labs, anywhere a magnetic stirrer is used. It fits into small spaces and can be easily transported to other labs or…
-
J-KEM® Miniature Overhead Stirrers
ChemglassMore power than stirrers ten times its size! Incredible 91in-oz of power yet fits in the palm of your hand! Safety - Low Voltage - Sparkless Sealed motor housing isolates motor from organic vapors Low voltage operation - Sparkless motor runs on 16 volts Convenience - Weighs less than…
-
Bearing, Trubore, 5 & 6mm
Ace GlassTrubore bearing with standard taper joint for use with our 9534, 9535 and 9541 precision ground stir shafts. Lubricant well at top will accept enough 8117 Stir-Lube to provide hours of operation at up to 1000 rpm. Match bearing ID with stir shaft OD.
-
Thomas No. 1177M31 Sturdy stand in a smaller bench footprint, for Caframo compact stirrer models BDC2002 and BDC2010. The unique offset design accommodates Caframo clamp so stirrer locates impeller in centre of vessel. The cast zinc-aluminum alloy base is coated for protection from corrosion and…
-
G.K.H. Stir Systems
Glas-ColDesigned to meet mixing requirements for varying viscosities and volumes Feedback circuitry to maintain speed when viscosity changes Reference circuitry to maintain speed even with voltage fluctuations of ±10% Cord connections between drive motors and controls Stirrers filter the drive…
-
Safe Operations Extremely resistant sealed case IP 54 Protection class is a guarantee of durability also when working in aggressive environment Full protection in case of overload, overtemperature and over current Lock key to prevent unintentional modification of the settings …
-
Inert to corrosives Easy to clean Bendable into shapes These Saint-Gobain Chemware ® PTFE Fluoropolymer Stirring Rods contain a fully enclosed steel insert for stiffness, yet can bend into various shapes for use with powders. Heat resistant to 550° (288°C) and completely inert to highly…
-
Material: 316l stainless steel ra32 finish or better inside & out Includes: dust shield, impeller shaft folding paddle Locking ring secures paddle in horizontal position Dimensions: 3"x9"
-
Features: Compact overall Height Brushless DC motor Micro USB port for Control or Data Logging of RPM/Torque trends RS232 Communication Port Torque Compensation – Maintains set RPM with Viscosity Changes Precise Digital Closed Loop Speed Control: +/- 1.5 RPM CE Rated …
-
Scilogex offers two efficient and carefully controlled digital overhead stirrer models for the safe and effective mixing of large volumes of liquids. LCD and LED Digital overhead stirrer models offer considerable functionality that would not be available on a standard analog overhead stirrer.…
-
MINISTAR control Overhead Stirrers
IKA WorksThe new MINISTAR series by IKA: Developed using the latest cutting-edge technology, this high-tech overhead stirrer with its compact design is ideal for special applications. Combining high performance with particular excellence, they require minimum space and come with a lifetime guarantee.…
-
Safe Operations Extremely resistant sealed case IP 54 Protection class is a guarantee of durability also when working in aggressive environment Full protection in case of overload, overtemperature and over current™ Lock key to prevent unintentional modification of the…
-
Arrow Propeller, Mixer Shaft
Arrow EngineeringAll propellers mixers are made of 316 stainless steel. They have a 5/16-24 internal thread for easy assembly with all of our stainless steel shafts. All stainless steel mixer shafts are made of 316 stainless steel. These quality mixer parts have a 5/16-24 external thread for easy assembly with all…
-
The DLS is a digital overhead stirrer for medium-low viscosity liquids. The technopolymer structure ensures optimum chemical resistance and enhanced handling, preventing any possible rust and being extremely light. The robust motor ensures years of continuous operation, with no extra costs…
-
LabJaws Support Stands
OhausSupport Stands are made entirely of 303 stainless steel. They have a durable base that can accommodate vessels up to 18" (457 mm) in diameter within the “U”. The base area is 17.75" (451 mm) across × 10.5" (267 mm) deep overall. The stainless steel support rod is…
-
Stirrer Accessories
Arrow EngineeringSupport Stand Steel base; legs have rubber pads to cut vibration Support rod is made of stainless steel. Height is 29”; available in two models. Jacob's Chuck, Adjustable Fits 3/8 ” (10 mm) diameter motor shafts Keyless Chuck, Nylon-bodied …
-
Air-Driven Stirrers
Arrow EngineeringModel 8583J10: Produces propeller speeds from approximately 200 to 10,000 rpm Compact and quiet; operates on compressed air at pressures from 30 to 100 psi (210 to 690 kPa) Sturdy, smooth-running motor develops 1/6 hp (120 W) at 80 psi (550 kPa) input Speed is variable by adjustment…
-
Stirrer, Laboratory, Solid State
Ace GlassTotally enclosed, 1/40hp DC permanent magnet motor with dual 8 mm (5/16") armature and gear shafts with milled flats. Armature shaft with maximum speed of 4000rpm.; 18:1 ratio gear shaft rated 3.6in-lb torque, up to 333rpm. Motor supplied with 1.5 meter 3-wire cable for controller connection.…
-
Caframo’s high torque stirrers are designed and engineered specifically to meet the continuous demands of heavy industrial use. The heart of the BDC line is the high performance Brushless Direct Current (BDC) motor. A unique two speed transmission provides incredible amounts of power. Caframo…
-
MICROSTAR digital Overhead Stirrers
IKA WorksThe space-saving high performers from IKA MICROSTAR and MINISTAR series have been complemented by additional models. The new and easy-to-use stirrers convince with perfect basic functionalities, as well as with a compact design. Combining high performance with particular excellence, they require…
-
Stirrer Blades PTFE construction Fit all standard shafts Will not scratch glassware Hole diameter: 6.5 mm Model 8596G58 to G70 shafts are for use with 8596G18 to G50 blades.
-
Short width stainless steel folding impeller assembly for standard bioreactor vessels 15l 316 l stainless steel Ra finish 32 micro inch or better (wxl) 3? x 7"
-
Manufactured from 316l stainless steel for standard bioreactor vessels. Use with over head drive motors.
-
PTFE Shafts and Propellers
Arrow EngineeringMUST BE ORDERED AS AN ASSEMBLY. A PTFE Propeller must be ordered together with a PTFE Shaft (each purchased separately).
-
Caframo’s BDC2002 offers ultimate versatility and maximizes productivity. With the push of a button, the unique Stirlight™ lights up so that solutions can be seen clearly. Included in each purchase: Overhead stirrer motor, chuck, chuck key, support rod, external power supply, grounded…
-
Laboratory Shakers/Roller/Rotator & Accessories
Oxford Lab ProductsThe Benchmate orbital shaker is a platform shaker that allows you to shake liquids and semi liquids to 7.5 kg in total weight.It may be used to to mix liquids in bottles, flasks, test tubes, and bowls with a variety of attachments. The Oxford Lab Products Digital tube rotator is ideal for a variety…
-
This lightweight micro stirrer is ideal for use with tissue grinders having stainless steel pestles. Supplied complete with a stirrer/controller, tripod with a vertical support rod, clamp holder and a coupling to fit the 6.35mm diameter of the stainless steel pestle rod.
-
PW Overhead Stirrers
VELPThe PW is the optimum solution for stirring high viscosity liquids. The technopolymer structure ensures optimum chemical resistance and enhanced handling, preventing any possible rust and being extremely light. The robust motor ensures years of continuous operation, with no extra costs for…
-
MM-1000 Overhead Stirrer Multi Mixer, 120v & Accessories
Grant InstrumentsThe MM-1000 is designed for stirring liquids up to 20 litres. It is a quiet and reliable mixer that provides stable continuous mixing for up to 7 days and features 3 types of motion: Rotational, Reciprocal and Vibration. It is an ideal instrument for biotechnology, organic synthesis, analytical…
-
Stirrer Accessories
ScilogexAccessory for OS20-Pro LCD, OS40-Pro LCD, OS20-S LED and OS40-S LED Digital Overhead Stirrers. Blade stirrer Gentle processing samples, used at low and medium speeds Polytetrafluoroethylene (PTFE) coating has low coefficient of friction against a solid