Corning, Equipment
-
-
Distilling Tube Connector
CorningStandard Taper 10/30 thermometer opening, distilling, three-way, Standard Taper joints Sidearm is at an angle approximately 75° from the lower part of the vertical tube The joint on the sidearm is at an angle approximately 105° from the sidearm The sidearm and lower tube…
-
Corning® Cell Counter
CorningAccurate Cell Counts in a Flash For years, the choice between manual and automated cell counting has been a difficult one. Manual cell counting, on the one hand, is accurate, but time-consuming and very userdependent. Automated cell counting, is much faster and less user-dependent, but the cost…
-
Gel Documentation Systems
CorningAxygen® Gel Documentation systems easily capture publication quality, 16 bit TIFF images. The systems are quick to set up and have an intuitive user interface for image capture, annotation, and contrast adjustment. Images are easily saved and opened in common gel analysis software for more…
-
Axygen® MultiRack Tip System
CorningFeatures: Reusable rack with reload systems Small footprint and stackable design for maximum bench space usage Extended tips offered in 10, 200, 300, and 1000 μL sizes Color-coded racks for easy volume identification The Axygen MultiRack tip system has been engineered to…
-
Condensers have water-jacketed Standard Taper inner joint. Complete with condenser, flask and extraction tube. The low thermal expansion rate means that the PYREX brand extractors can be routinely used in applications requiring protracted heating at temperatures as high as 230°C. The inherent…
-
PYREX Stark-Dean
CorningPYREX®10 mL , Stark- Dean For use in the determination of water in petroleum products and bituminous materials Graduated in 1/10 mL divisions from 0 to 1 mL ; in 1/5 mL divisions from 1 to 10 mL With Standard Taper 24/40 joints; meets ASTM Standard E 123
-
LSE™ 6L Digital Water Baths
CorningThe Corning LSE Digital Water Bath is a personal-sized bath constructed from corrosion resistant stainless steel. The seamless chamber can accommodate up to 6 liters of water or can serve as a dry bath when using thermal beads. Temperature can be set from between ambient +5°C and 99°C and…
-
Single Block, 20 x 2.0 ml tubes
CorningThis is a single block, 20 x 2.0 mL tubes, for use with Corning® LSE™ Digital Dry Bath Heater.
-
Axygen® Axypet® Pro Pipettors
CorningAxygen Axypet Pro Pipettors have been engineered to provide the highest levels of comfort, accuracy, and precision. The lightweight construction, contoured handle, and 4-digit counter were designed to ensure comfortable pipetting. All pipettors feature smooth plunger movement and extremely low…
-
Multi Position Stirrers
CorningReliable DC motors Available in 4, 5 and 9 position models Stirs at speeds up to 2,000 rpm Stir up to 9 vessels at the same time with these Multi Position Stirrers. The stirrers' magnets and DC motors provide smooth well-coupled stirring up to 2,000 rpm. The speed of all positions on the units…
-
PYREX Cloud & Pour Test Jars
CorningFor ASTM D-97, D-1500, D-2500 Cylindrical with flat bottom, beaded rim and marking spot Height 121 mm; o.d. 35 mm With graduation ring 51 mm from bottom
-
Corning® Lambda™ EliteTouch™ pipettors have been engineered to provide the highest levels of ergonomics, accuracy, and precision. Lightweight construction, contoured shape of the handle, and 4-digit counter were designed to ensure comfortable pipetting. All pipettors feature smooth…
-
Economical Compact design Stirring range: 100-1600 rpm Rugged construction The unit’s 5” x 5” top size saves valuable bench space. Alternating current motor and strong magnet provide longer life and vigorous stirring. Top is constructed of plastic. Stirrer has a one-year…
-
These PYREX® condensers have a high surface area per unit length of the 300mm long jacket with a 24/40 Standard Taper outer joint at the top and a plain drip tip at the bottom. They are primarily used in distillation assemblies. Condenser tubulations are approximately 10mm O.D.
-
PC-611 Stirrer
CorningThese Corning® PC-611 stirrers have an 11 x 11 inch plastic (ABS) top and can stir large volumes of liquid with ease. These stirrers are designed for 5 gallon vessels (19L), but can stir up to 10 gallons and can handle many applications that previously required an overhead stirrer. This powerful…
-
Lambda™ EliteTouch™ Starter Kit
CorningCorning Lambda EliteTouch Starter Kit contains 4 variable volume pipettors in the most popular and universal volumes (0.5-10 µL, 2-20 µL, 20-200 µL, and 100-1000 µL), pipet stand for 4 pipettors, 3 racks with tips, and accessories. Cat. No. 6051 Lambda EliteTouch…
-
Ammonia In Water Distilling Unit
CorningConsists of flask, connecting tube and condenser Inlet tube on connecting tube permits the introduction of the permanganate solution after distillation of free ammonia. 9849F20 flask has Standard Taper 29/42 mouth; capacity is 500 mL. Condenser is coiled-tube type, 200 mm jacket length, with…
-
With outer Standard Taper joint at the top and an inner-sealed through drip-tip joint at the bottom Bent at 105° angle The serrated sidearm is 10 mm O.D. drip-tip at the bottom extends about 20 mm below the lower end of the joint
-
This 47 mm fritted glass support base is designed for assembly with either the 300 mL graduated glass funnel, Cat. No. 33971-300 or 1000 mL graduated glass funnel, Cat. No. 33971-1L.
-
This 1000 mL graduated funnel, 47mm is designed for assembly with the fritted glass support base, Cat. No. 33972-B. Disclaimer: This product is not intended to mitigate the presence of microorganisms on surfaces or in the environment, where such organisms can be deleterious to humans or the environment.
-
This specially designed PYREX® cold finger condenser is a replacement part for the PYREX® Cyanide Distilling Apparatus (Thomas No. 0320A91)
-
The Corning LSE Low Speed Orbital Shaker includes a 30 x 30 cm platform and is ideal for staining and destaining gels, washing blots and general mixing applications. Speed can be set from 3 to 60 rpm and the timer can be set for up to 2 hours or for continuous operation. Ideal for staining…
-
Corning® LSE™ Nutating Mixer
CorningThree-dimensional gentle mixer The Corning LSE Nutating Mixer is a compact mixer that combines the motion of an orbital shaker and a platform rocker to produce a continuous three-dimensional agitation. The output demonstrates a thorough yet gentle mix without foaming. This mixer is safe to use…
-
Falcon Pipette Controller - St
CorningThe light, ergonomic, motorized pipet controller Designed for use with glass and plastic serological pipets from 0.5 to 100 mL volume ranges. Conveniently positioned switches change operating modes and speeds quickly to handle different liquid volumes and viscosities. Aspirating and…
-
400640 & 402645: Reusable Spinner Direct Top Drive Motor High torque, low rpm stirrer motor specifically designed to maintain constant low speed for use on top of Corning® Reusable Spinner Flasks. The gearhead stirrer motor delivers 14.5 in-lbs of torque and has a maximum speed of 350…
-
Corning® Boss Head Support Clamp
CorningCorning offers a 2" long right angle black anodized aluminum Boss Head clamp that will accept up to 7/16" diameter support rods. It is designed to be used with the Corning Temperature probe support clamp (Cat. No. 440141).
-
These PYREX® extra coarse porosity fritted thimbles are designed for use in PYREX® Soxhlet extractors when it is desirable to weigh the material extracted or where paper thimbles may be attacked by the chemicals used. For PYREX® extractors and extraction apparatus, see Nos. 3740 through 3880. .
-
This PYREX® Friedrichs type condenser affords very efficient operation. The helical inner tube fits closely within the jacket. The vapor tube is sealed to the jacket at an angle of 75° and has an outer 24/40 Standard Taper joint.
-
This 2.4L PYREX® desiccators is designed for general analytical work. The sturdy knob makes the cover easy to handle. Approximate bowl volume is 2400mL. For replacement cover, see No. 3081-150CO. For lower part only, see No. 3081-150LO. Warning: Do not heat or subject to pressure. Not for…
-
Tubes for general chromatographic analysis Tops are tooled for rubber stopper fit and tubes are fabricated with sealed-in coarse porosity fritted discs Outflow tubes eliminate the smearing of the definition bands of effluent caused by the tube being filled and solvent mixed before being…
-
Organoid Counting Software
CorningBy purchasing the software extension, customers will be able to accumulate concentration in orgs./mL and collect surface area data in micrometers squared of their 3D cell cultures; a feat that existing standalone brightfield cell counters simply cannot offer. At launch, we are introducing 2…