Thomas No. 8613Q26
For fastening the holding rod H 38 to the support rod H 16 V.
Clamping range - stand: 10 - 11 mm
Clamping range - extension arm: 11 mm
Material: cast aluminium
Thomas No. 1207N21
For fastening the T 10 basic to the stand ST 104 (included with delivery of T 10 basic).
Thomas No. 8588A34
Clamping range - stand: 6 - 16 mm
Clamping range - extension arm: 6 - 16 mm
Material: cast aluminium
Thomas No. 8588A40
Clamping range - stand: 25 - 36 mm
Clamping range - extension arm: 5 - 21 mm
Material: cast aluminium
Thomas No. 3410Q20
Specialized clamp with openings for the stands R 2722 and R 2723 as well as extensions with Ø 16 mm.
Clamping range - stand: 34 mm
Clamping range - extension arm: 16 mm
Material: cast aluminium
Thomas No. 1227W25
For fastening ETS-D5 or ETS-D6 to the support rod H 16 V.
Thomas No. 8613Q23
Stainless steel support rod for all magnetic stirrers with M 10 threaded bushing.
Thomas No. 1203D35
For work with bath attachment over 180 mm Ø.
Thomas No. 1203D36
For clamping flask necks, condensers, etc. up to 11 cm diameter.
Thomas No. 3410Q23
For securing vessels against walls or for synchronized rotation during stirring or dispersing.
Thomas No. 3410Q24
For clamping flask necks, condensers, etc. up to 11 cm diameter.
Thomas No. 8588A51
Required for stirring tasks using glass stirring rods. The flexible coupling compensates for any structural variances.
Thomas No. 1203D37
Prevents potential injuries at the rotating shafts and stirring elements. Can be directly attached to the EUROSTARs, RW 16 basic, RW 28 basic and the RW 20 stirring motors.
Thomas No. 1203D38
For fixing the stirring shaft protection R 301 to the stand.
Thomas No. 1203D39
Prevents potential injuries due to the rotating shafts and stirring elements. Can be directly attached to the stirrer RW 47 D.
Thomas No. 1203D40
The SI 400 consists of an end switch (normally closed contact / switch) and a magnetic switch contact (actuator) which is mounted on the floor stand R 472 with the fixing device SI 472 and on the telescopic stand R 474 with the fixing device SI 474. The stirring unit RW 47 can only be switched on through the SI 400, when the agitator is adjusted in the mixing vessel to the user designated height. The power of the RW 47 automatically shuts off if the stirring unit is lifted off the designated height.
Thomas No. 1203D41
To attach the safety switch SI 400 to the floor stand R 472.
Thomas No. 1203D42
To attach the safety switch SI 400 to the telescopic stand R 474.