Ready-to-use No assembly required Provides an unrestricted view of tubes Available in 2 sizes: 13 and 16 mm and four colors: white, blue, green and red. Do not autoclave.

Full-size Unwire test tube racks securely hold a full load of test tubes or centrifuge. Up to 72 of the smaller diameter tubes can be held at once. Molded in six bright, permanent colors Resmer™ manufacturing technology makes these racks keep their bright colors longer. Useful in a wide…

Smooth finish leaves fewer places for contaminants to lodge; no welds to break, no sharp edges. Endplates accept large labels for easy identification of samples. Higher specific gravity than water so it stays submerged in a water bath and won't float. Withstands most lab chemicals and…

Constructed with Thermo Scientific™ Resmer™ Manufacturing Technology. Racks are repeatedly autoclavable. Smooth finish leaves fewer places for contaminants to lodge; no welds to break, no sharp edges. Endplates accept large labels. Rack withstands most lab chemicals and…

Designed for transportation of potentially hazardous materials in racks Constructed of clear polycarbonate with a silicone gasket Autoclavable Four polysulfone clamps securely lock the top and bottom together. Dimensions: 14.5” x 7.3” x 6.687” (368 x 184 x 171…

Non-scratching Empty racks can be stacked Tube-centering depressions in bottom shelf are perforated. The hole rows have molded-in numbers and letters. Not autoclavable. All racks are 115 mm wide x 95 mm high.

Cannot rust, chip or scratch Letters and numbers identify tube locations Assorted colors available These racks are similar to 9259J65 series, but are half the size to accommodate tubes up to 25 mm diameter. They have a 4 x 4 array and are molded of glass-reinforced polyketone. The racks’…

Usable in cold rooms and at subfreezing temperatures Racks can be used in water baths, as they do not float Similar to 9259S10 series, but constructed of polycarbonate. Racks’ upper two shelves and handles are clear; the bottom shelf is opaque. Can be autoclaved occasionally, but repeated…

Molded of glass-reinforced polyketone No vinyl or epoxy coating to chip or scratch Assorted colors available Racks are molded in one-piece in a 3 x 3 array. The three-tier design has letters and numbers to identify tube locations.The racks’ thermal properties allow both autoclaving and…

Incubate liquid cultures on a slant using Thermo Scientific™ Nalgene™ Test Tube Slant Racks. Slant racks allow 5 or 20 degree tilt to allow media to harden at an angle for incubating liquid cultures. These racks are keyed with numbers and letters for easy identification and are…

Autoclavable Consists of an array of pegs spaced to hold tubes while allowing full view of contents Pegs convenient for holding inverted tubes for drying When racks are inverted, ribs keep tubes off base to allow drainage through holes 9260B01 and B13 are 13 mm with an array of 8 x…

Full-size Unwire test tube racks securely hold a full load of test tubes or centrifuge. Up to 72 of the smaller diameter tubes can be held at once. Molded in six bright, permanent colors Resmer™ manufacturing technology makes these racks keep their bright colors longer. Useful in a wide…