Labconco, Supplies
-
-
CentriVap® Complete™ Concentrator
LabconcoCentriVap Complete. All-in-one vacuum concentrator. Includes -50° Cold Trap, Diaphragm Pump, Rotor and CentriZap (allows sample viewing while run is in progress). Plug and play unit. Heat boost and acid resistant models available. Holds up to 100 12-13 mm tubes or 40 microcentrifuge tubes.…
-
8-Place Pipet Insert
LabconcoHolds 8 pipets, 1 ml to 10 ml. Includes one 1.25" mounting spindle. One each. FlaskScrubber and FlaskScrubber Vantage Series Washers hold up to four 4494200 Inserts. Pipet Inserts permit direct injection cleaning of pipets. Self-sealing silicone check valves allow washing of partial or…
-
Protector Premier I-S Laboratory Hoods incorporate a sleek interior with a molded one-piece fiberglass liner, the signature feature of Labconco’s leading line of fume hoods since 1961. The one-piece liner of specially-formulated, fiberglass-reinforced polyester offers corrosion and fire…
-
-
-
3' Nexus Horizontal Clean Bench. 26" deep work area with standard interior. Features laminar, ISO Class 4 airflow, intelligent OS with 5” touchscreen and an ECM motor with CAP™ Technology.
-
Protector Pass-Through Laboratory Hoods offer sashes on two sides allowing operation on either side of the fume hood. An audible alarm sounds to prevent simultaneous opening of both sashes. With unobstructed visibility from either side, this hood is ideal for conducting chemistry demonstrations. …
-
Neutralizing Acid Rinse
LabconcoSpecially formulated for Labconco SteamScrubbers® and FlaskScrubbers® Rinses completely Rinse alters the pH of wash water to reduce alkaline detergent carry over. It removes hard water residue, including mineral deposits, accumulated salts and lime scale that can cloud glassware.
-
Centrivap Cold Trap
LabconcoCFC-Free 4 liter stainless steel collector An epoxy coated aluminum base with an acrylic/PVC thermoplastic control panel. Reaches -55°C in less than 15 minutes. Ultra-Low Cold Trap reaches -85°C in less than 30 minutes. Ready indicator illuminates when the collector coil reaches…
-
Compact footprint, only 8.8" w x 10.4" d x 8.9" h (21.5 x 24.1 x 17.0 cm), requires little bench space or storage space. - Built-in Teflon-coated diaphragm pump with ultimate vacuum of 160 mBar and displacement capacity of 5.5 liters/minute IR-emitting transparent glass lid …
-
Hexagonal Acid-Resistant Rotor
LabconcoTeflon-coated aluminum hexagonal rotor with Teflon hub holds microcentrifuge tubes at an angle to maximize surface area. Holds up to 132 1.5 to 2ml tubes.
-
Service Fixture Kit Yellow Vacuum
LabconcoKit includes copper tubing, brass valve and yellow knob/connector. Max. flow rate of 8.6 CFM. Max. working pressure of 14.7 psi. Kits mount on the right or left side of any Protector Premier, XStream, XL, XLE or PVC Hood. Each kit includes one remotely-controlled service fixture with valve and…
-
Class II Cabinets IV Bar Kits
LabconcoIV Bar Kit for Purifier Logic Biosafety Cabinets and PuriCare Procedure Stations Kit includes: IV bar, mounting hardware, four hangers and instructions for installation
-
-
-
Ideal for fume hood exhaust systems in moderate to highly corrosive conditions. Intelli-Sense Multi-Speed Blowers are weatherized, direct drive, non-explosion-proof blowers controlled by a two or three position switch. Each blower has a reliable electronically commutated motor (ECM), which…
-
The Purifier Axiom Class II, Type C1 is the first biological safety cabinet that can be used in a recirculating Type A-mode for standard microbiological work, or can be connected to an exhaust system to function in Type-B mode for handling hazardous chemical vapors or radionuclides. Because of the…
-
XPert Filtered Balance Systems provide user protection by keeping powders and particulates contained during weighing procedures. Patented features include an ergonomic air foil with Clean-Sweep openings to enhance airflow and a zone-perforated rear baffle that creates horizontal laminar airflow to…
-
Logic Vue Safety Interlock Cable
LabconcoSafety Interlock Cable provides interface between the Logic Vue and automation devices that employ a safety interlock. Opening the sash of the Vue triggers the interlock, immediately signaling a device to pause or stop.
-
Labsolutions Detergent
LabconcoShining results in any automatic laboratory glassware washer Rinses glassware completely Non-foaming formula Economical Removes lab contaminants such as grease, blood, agar and protein digestates. Just one scoop is needed for most wash cycles. Scoop included in every container…
-
Fiberglass 30 Laboratory Hoods
LabconcoCompact, benchtop Fiberglass 30 Laboratory Hoods are designed for research, educational and clinical applications requiring small working space and efficient fume removal. The fiberglass liner is corrosion-resistant, durable, fire-resistant and light reflective. The smooth one-piece molded…
-
Hand-held Digital Hygrometer
LabconcoHand-held Digital Hygrometer is a battery operated instrument that measures both percent relative humidity from 0-100% with +/-2% accuracy and temperature in °F or °C with +/-0.54° F accuracy. Calculates the dew point temperature and wet bulb temperature based on the relative humidity…
-
Liquid Glassware Washer Detergent
LabconcoLow-foaming Non-corrosive formula Chlorine-free Specially formulated for Labconco SteamScrubbers ® and FlaskScrubbers ® . Detergent removes a wide range of laboratory contaminants and rinses completely. Will not degrade stainless steel, glass or plastic and it can be used in…
-
-
Pressure Switch for FlaskScrubber and SteamScrubber Glassware Washers. Replacement parts and accessory parts for Labconco glassware washers.
-
Protector Airo Filtered Fume Hoods
LabconcoThe Protector® Airo™ Filtered Fume Hood has a compact design that avoids potential challenges of existing lab conditions while still providing space, utility and options of a traditional hood. It features all of the characteristics of Labconco Protector Hoods including the patented…