PYREX®10 mL , Stark- Dean For use in the determination of water in petroleum products and bituminous materials Graduated in 1/10 mL divisions from 0 to 1 mL ; in 1/5 mL divisions from 1 to 10 mL With Standard Taper 24/40 joints; meets ASTM Standard E 123

Dish dimensions including lid 114 x 213 x 83 mm high overall; min. depth approx. 67 mm

Ground glass cap Wheaton 400 borosilicate glass Supplied with glass stopper This burner, manufactured from soda-lime glass, is designed for use with isopropyl or denatured ethyl alcohol. Its low-heat flame is well suited for microscopy purposes. The unit is supplied with a…

Used for continuous extraction of analytes from a solid into an organic solvent WHEATON Connection eliminates the need for hooks, springs and clamps common to standard ground joint designs As the flask containing the solvent is heated, vapors rise in the larger outside tube, enter the…

10-/20-slide unit This 20-slide unit is the standard for manual staining procedures. The removable glass slide rack has an open bottom to facilitate rapid immersion and drainage and eliminate carryover. The rack holds 10 single slides, 19 slides arranged alternately straight across and…

Consists of flask, connecting tube and condenser Inlet tube on connecting tube permits the introduction of the permanganate solution after distillation of free ammonia. 9849F20 flask has Standard Taper 29/42 mouth; capacity is 500 mL. Condenser is coiled-tube type, 200 mm jacket length, with…

The Kuderna-Danish apparatus was developed in the laboratories of Julius Hyman and Company for the concentration of trace amounts of sample dissolved in organic solvents. The column is designed to speed evaporation with reduced hold-up. It is very useful in sample preparation before analysis with…

This staining dish can hold up to 4 cover slips measuring 17-23 mm wide, and up to 30 mm long. Longer cover slips can be accommodated if the cap is removed. The jar comes with a white polypropylene screw cap with a PTFE coated polyethylene liner. It is manufactured from soda-lime glass and is…

Developed in the laboratories of Julius Hyman and Company for the concentration of trace amounts of sample dissolved in organic solvents. It is very useful in sample preparation before analysis with solvents such as petroleum ether or hexane. Preparation involves filling the flask to between…

Apparatus is for determining the proteinaceous nitrogen content in water. It is also useful for preparing small quantities of distilled water. Apparatus can be used for phenol, selenium and fluoride determinations. It has 24/40 Standard Taper joint and a #2 hose connection. Unit measures 595 mm H x…

Coplin Staining Jar, 5-10 Slide Unit (8541L01) This unit holds ten 3" x 1" (75 mm x 25 mm) slides, back-to-back that extend above the opening so you can manipulate them without using forceps Polypropylene screw cap The screw cap is made of linerless white polypropylene to…

Available exclusively from Thomas® Scientific Filter, de-gas, deliver and store HPLC Mobile Phase safely and easily and improve the performance of automated HPLC systems. Chromaphase Handling Systems eliminate the hazardous withdrawal of solvents from reagent bottles and provides…

For gravimetric oil and grease Three position linear system Heating mantle, controller and splash guard are required for complete system (clamps and support included): power 15 amps - 115 volts. Refrigerating circulator recommended for system water coolant: -4°C. Proper ventilation…

A general purpose batch distillation assembly with the facility for addition via the Standard Taper PYREX® stopped neck Ideally suited for the batch production of high purity distilled water The flask bottom is flat with a slide delivery tube, terminating in a Standard Taper joint …

Without stopcock 5579M10 Buret is graduated from 0.5 to 50 mL in 0.1 mL divisions, tolerance ±0.10 mL.