Kemtech America Glass Joints & Adapters
-
SYNTHWARE Vigreux Distilling Columns
Kemtech AmericaColumn length is measured from the highest to lowest indent in the column.
-
Synthware Claisen Adapters, Modified
Kemtech AmericaIt is modified with an additional side arm at 45 degrees to the vertical outer joint. All joints are the same size.
-
SYNTHWARE Short Path Distilling Head for Volatile Solvents
Kemtech AmericaWith the condenser being a combination of a cold coil and Leibig. Top outer joint is a 10/18 for use with a 50mm immersion thermometer. For best result, use D272440.
-
Synthware Reducing Adapters
Kemtech AmericaSynthware reducing adapters are used for connecting dissimilar standard taper joint sizes. The lower inner joint is larger in size than the top outer joint.
-
SYNTHWARE Graduated Distilling Cow Receiver
Kemtech AmericaTubes are graduated from 0-3mL in 0.2mL subdivisions.
-
SYNTHWARE Cow-Type Distilling Receivers with Hose Connection
Kemtech AmericaCow-type design having three receivers spaced 40° apart. 105° angle between top outer joint and lower inner joins.
-
SYNTHWARE Hickman-Hinkle Still Head with Side Port
Kemtech AmericaHickman-Hinkle Still Head, with Side Port, Synthware, Joint: 14/10, for microscale fractional distillation, supplied with one compression cap, one Viton O-ring and one PTFE-faced silicone septum.
-
Synthware Kjeldahl Distilling Trap Adapters
Kemtech AmericaAdapter is placed above flask to prevent carry-over of reactions which have a tendency to foam. With top outer and lower inner standard taper joints.
-
Synthware Connecting Adapters
Kemtech AmericaSynthware combination adapting connector with a top spherical socket joint and a lower standard taper inner joint.
-
Synthware "U" Shaped Drying Tubes
Kemtech AmericaSynthware "U" shaped drying tube. With a lower inner standard taper joint. Cotton is typically used to contain drying agent.
-
SYNTHWARE Glass Check Valves
Kemtech AmericaCheck Valve, All Glass, Synthware, Hose Connections OD: 8mm, with ground seat for liquid seal.
-
SYNTHWARE Solvent Still, Built-In Condenser
Kemtech AmericaSolvent Still, Built-In Condenser Capacity: 125mL Joints: 24/40 Threaded Side Port: 14/10
-
SYNTHWARE Distillation Adapter
Kemtech AmericaDistillation Adapter, Microscale, Synthware, Joints: 14/10, supplied with one compression cap, one Viton O-ring and one PTFE-faced silicone septum.
-
Synthware Tapered Distilling Adapters
Kemtech AmericaWith an outer standard taper joint at the top. The tapered delivery drip tube extends into open receivers.
-
Synthware rotary evporator anti-splash trap, modified. With extra coarse porosity fritted disc sealed above lower inner joint. Trap is placed between the vapor tube and the evaporation flask. This design prevent possible contamination in the event of bumping. Frit reduces foam overflow from being…
-
SYNTHWARE Vacuum Adapter with PTFE Stopcock
Kemtech AmericaVacuum Adapter, Microscale, PTFE Stopcock, Synthware, Joint: 14/10, Stopcock Bore: 2mm, Hose Connection OD: 8mm.
-
SYNTHWARE Microscale Vigreux Distilling Heads
Kemtech AmericaWith Vigreux Indentations, used with 25mm immersion thermometer, and D27 distillation receiver.
-
SYNTHWARE Distillation Receivers
Kemtech AmericaWith the outer and inner joint at 135° angle, used with short-path.
-
Synthware Thermometer Adapters
Kemtech AmericaSynthware thermometer adapter with a 5 degree offset and a serrated hose connection for vacuum. Joints are standard taper.
-
Synthware Vacuum Transfer Adapters
Kemtech AmericaSynthware vacuum transfer adapter with PTFE stopcocks and standard taper inner joint. Used for the transfer of sensitive and hazardous solutions while under vacuum.
-
SYNTHWARE Peptide Synthesis Vessels, Solid Phase
Kemtech AmericaPeptide Synthesis Vessel, Solid Phase, Synthware, Capacity: Available in sizes ranging from 10-50mL, Frit Porosity: Coarse or Medium, Frit Diameter: Available in sizes ranging from 15-25mm, GL Thread: 14 or 25 available, Arm OD: 8mm, Supplied with a PTFE lined cap and straight bore PTFE stopcock…
-
Synthware Distillation Adapters, Vigreux
Kemtech AmericaSynthware Vigreux distillation connecting adapter. Indenstations in lower section improve liquid/vapor contact. The standard taper top outer joint accomodates a 76mm immersion thermometer. Bottom and side joints are standard taper inner joints.
-
SYNTHWARE Distillation Cow Receiver
Kemtech AmericaDesigned for microscale application. With one female joint and four drip-tip male joints.
-
Synthware Rotary Evaporator Anti-Splash Traps, Modified
Kemtech AmericaTrap is placed between the vapor tube and the evaporation flask. This design prevent possible contamination in the event of bumping. With two 4mm drain holes at the base of the inner tube to allow solvent to drain back into the evaporation flask. Has upper outer and lower inner standard taper joints.
-
SYNTHWARE Distillation Receiving Set
Kemtech AmericaComes with Synthware Distilling Adapter (Joints: 14/20, 19/22 AND 24/40) and Cow Receivers (Joints: 14/20, 19/22, AND 24/40). Rotating cow receiver allows four flasks to be progressively filled. **NOTE THESE PRODUCTS COME IN DIFFERENT SIZES - WHAT IS PICTURED MAY NOT BE THE ITEM SOLD**
-
SYNTHWARE Solvent Still Head with Drainage Port
Kemtech AmericaSolvent Still Head Capacity: 500 and 1000mL available Top Joint: 24/40 Bottom Joint: 24/40 and 29/42 available Side Joint: 14/20 Drainage Port Joint: 14/20
-
SYNTHWARE Microscale Distillation Apparatus
Kemtech AmericaMicroscale Distillation Apparatus has a short-path design for microscale application, used with 25mm immersion thermometer, and D27 distillation receiver.
-
SYNTHWARE Claisen Adapter
Kemtech AmericaClaisen Adapter, Microscale, Synthware, Joints: 14/10, supplied with two compression caps, two Viton O-rings and two PTFE-faced silicone septum.
-
SYNTHWARE Snyder Distillation Column
Kemtech AmericaSnyder Distillation Column, 3 Section Top Outer Joint: 24/40 Lower Inner Joint: 24/40 Column Height: 150mm Overall Height: 300mm For use with Kuderna-Danish flask.
-
Synthware Flow Control Adapters with Metering Stopcock, 90°
Kemtech AmericaSynthware flow control adapter with metering stopcock. The serrated hose connection is turned 90 degrees to the standard taper inner joint. Provides on/off control with the main stopcock and precise control of liquids or gasses with the needle valve.
-
SYNTHWARE Micro Vigreux Distillation Head
Kemtech AmericaDistillation head with condenser sealed to a Vigreux column. Vacuum adapter has an outer joint and accepts a distribution adapter (D201414). To be used with a 25mm immersion thermometer.
-
Similar to D451414-series but with the uptake tube vacuum jacketed to improve distillation performance. The jacket eliminates the possibility of condensation or recrystallization of distillate in the sidearm. With 2mm PTFE stopcock.