Autoclavable Consists of an array of pegs spaced to hold tubes while allowing full view of contents Pegs convenient for holding inverted tubes for drying When racks are inverted, ribs keep tubes off base to allow drainage through holes 9260B01 and B13 are 13 mm with an array of 8 x…

Smooth finish leaves fewer places for contaminants to lodge; no welds to break, no sharp edges. Endplates accept large labels for easy identification of samples. Higher specific gravity than water so it stays submerged in a water bath and won't float. Withstands most lab chemicals and…

Constructed with Thermo Scientific™ Resmer™ Manufacturing Technology. Racks are repeatedly autoclavable. Smooth finish leaves fewer places for contaminants to lodge; no welds to break, no sharp edges. Endplates accept large labels. Rack withstands most lab chemicals and…

Cannot rust, chip or scratch Letters and numbers identify tube locations Assorted colors available These racks are similar to 9259J65 series, but are half the size to accommodate tubes up to 25 mm diameter. They have a 4 x 4 array and are molded of glass-reinforced polyketone. The racks’…

Ready-to-use No assembly required Provides an unrestricted view of tubes Available in 2 sizes: 13 and 16 mm and four colors: white, blue, green and red. Do not autoclave.

Molded of glass-reinforced polyketone No vinyl or epoxy coating to chip or scratch Assorted colors available Racks are molded in one-piece in a 3 x 3 array. The three-tier design has letters and numbers to identify tube locations.The racks’ thermal properties allow both autoclaving and…