Unique gravity-sealing design Two-piece construction One-handed operation Large membrane access points for forceps Available in polysulfone or polypropylene No clamps or locking devices to manipulate. Less expensive than stainless steel, glass or magnetic funnels, yet compare favorably with…

Sartolab® Vacuum filtration units are designed for the convenient clarification & sterile filtration of tissue culture media and components, biological fluids, and other aqueous solutions. Sartolab® RF BT vacuum filtration units are available as ready-to-use disposable 50 mL, 150 mL,…

Set of seven neoprene adapter cones designed to fit Buchnew and fritter glass funnels, porcelain filters without headpieces, and for reverse flow cleaning for filter crucibles. Adapters can be used to support funnels, Gooch crucibles, filter tubes and other apparatus in filtration…

Easy-to-clean two-piece, polypropylene plastic Buchner funnels include a molded in perforated plate. Lightweight; not top-heavy Steam autoclavable at 121°C (250°F) Use with Vac-Ring Filter Seal (1189N06) for quick filter setup

KIMAX funnel used wherever filter paper and membranes cannot withstand the chemical attack of the filtrate. Funnels are constructed with heavy-walled stems, and top rims are beaded for extra strength. With a marking spot. Designed from Federal Specification DD-F-776.

Analytical Filter Funnel, Polystyrene; Cellulose Nitrate (C.N.) Membrane CONTAINS FILTERS ONLY Nalge 140 47 mm diameter filter with grid Ideal for use with filtering flasks or manifolds Convenient snap-away design with removable membrane; funnel marked at 100 mL …

Cylindrical funnels have a pressure equalizing line, a PTFE stopcock, and a lower drip tip Graduations to the stopcock are numbered both up and down Manufactured from 33 expansion, low extractable borosilicate glass conforming to USP Type I and ASTM E438, Type I, Class A requirements

Cylindrical with standard taper joint at top and bottom and drip stem. Stopcock on equalizing arm permits filling funnel without having to open the system to atmosphere. For replacement stopcock plugs, see 8224. For stoppers, order 8250-12 or 8255-10.

Ready-to-use 100 mL filtration units with removable cellulose nitrate membrane and culturing devices. Saves up to 50% in time with no flaming and sterilization required Minimizes the risk of cross contamination Easy release of membrane

The CoorsTek Buchner funnel is used for separation and filtration of solids from liquids. The fixed perforated plate at the bottom contains small pores that allow the liquid to pass through while retaining the solid particles. It has glazed inside and out except for rim. Ceramic Buchner funnel…

FILTER FUNNEL Filter funnel measuring 3" wide. Useful for separating solids from liquids, as well as for easier transfers of liquids to narrow mouthed containers INDUSTRIAL QUALITY Made of chemical resistant polyethylene plastic 3 INCH STEM Funnel stem measures 3" in length with an outer…

Filter support collars are ideal for supporting glass funnels, crucibles, Büchner funnels, and other filtration devices. The rubber collar forms a gas-tight seal during vacuum filtration. Rubber Tapered Filter Adapter Complete Set of 8 different sizes. Size 1-8 as listed as height, top inner…

Sartoclear Dynamics® Lab kits are designed for rapid harvesting 15 mL to 1,000 mL volumes of cell cultures in the lab, enabling clarification and sterile filtration to be performed in one step. These kits simplify the process by fully eliminating the centrifugation step otherwise needed for…

Used in applications where it is necessary to wash and re-dissolve the precipitate with chemicals that would attack standard filter paper. The 60º angle on the funnel permits removal of precipitates.

Buchner Funnels with Inner Joint and Perforated Glass Plate.

Buchner funnel includes fixed perforated plate. Funnels are glazed on inner and outer surfaces except for the rim. Thermal Shock Resistance - average coefficient of expansion from 20° C to 200° C is 3.56 x 10-5, gradually increasing to 4.69 x 10-5 at 1050°C. Every batch of…

With standard taper stopper joint. Stopcock available 1:5 PTFE plug. Stopper size is standard taper 24/40. For replacement stopcock plugs, see 8224. For stoppers, order 8250-12. Stopper NOT supplied.

Table-top Buchner funnels with coarse porosity (90-130 microns) with a removable punctured filter plate. The high density polyethylene rigid plate is 4.8mm (3/16") thick. Holes are 4.8mm (3/16") diameter on 11mm (7/16") centers. A removable filter plate allows easier cleaning and…

MICROFILTRATION WITH GROUND JOINT The 90 mm filtration assembly with fritted glass support is designed for large volume filtration analysis of corrosive liquids or samples with high particulate loads that would tend to clog a 47 mm diameter filter.  This unit is also recommended for…

Inside flutings for rapid filtration For use in flasks or test tubes without filter rack

Designed for bacteriological analysis where it is necessary to sterilize the filter holder with the membrane filter in place. The glass surface is coated with PTFE to avoid filter damage and membrane adhesion during autoclaving. Complete set includes a PTFE-faced borosilicate glass funnel and…

Buchner style filter funnel having a lower standard taper inner joint and serrated tubulation for connection to a vacuum source. Disc diameters and height above the disc are the same as CG-1402. Improved design incorporates a delivery stem being sealed within the inner joint to prevent breakage.…

Cylindrical with joint at top and bottom and drip stem. Stopcock on equalizing arm permits filling funnel without having to open the system to atmosphere. For replacement stopcock plugs, see 8224. For stoppers, order 8250-12 or 8255-10.

Durable, break-resistant, non-toxic polysulfone exhibits low protein- binding and is easy to clean Same funnel design as glass funnels without breakage problems Upper reservoir is graduated in 25 mL increments from 100 to 250 mL Unique fit of upper and funnel sections ensures no…

Similar to CG-1402 but with a water jacket enclosing the funnel bowl and upper portion of the stem. Jacket permits heating or cooling of the contents of the funnel during filtration. Stem length listed is the length below the jacket.

With ACE fritted disc. Porosities A, B, C and D are priced the same.

This unique disposable filter funnel system for solid-liquid separation can be used in chemistry and biological laboratories. The system consists of a polypropylene filter funnel with silica gel/polyethylene fritted disc, a CG-1049-J style glass vacuum adapter, and a flask or vial. The…

Good quality glazed porcelain. Acid and alkali resistant. Sold as eaches.

For standard filter papers Body is at 60° angle with internal ribs at 58° for rapid filtration Outside ribbing eliminates air lock Autoclavable

Funnels are to be used in conjunction with vacuum source to filter and collect fluids.

Lightweight and durable Bottom and top can be separated for easier cleaning Autoclavable

Unsurpassed for non-vacuum, high-speed filtration, these clear funnels have internal helicoid ribs to increase the filtration speed. Vertical outer ribs prevent airlock Autoclavable polymethylpentene plastic; unaffected by corrosive liquids Heat resistant to 177ºC (350ºF)