Thin Layer Chromatography (TLC) Plates
-
Thomas Glass Sprayer
labForce® (powered by Thomas Scientific)Provides uniformly fine mist or spray, required for paper chromatographic determination Conveniently located vent permits instantaneous control of spray Borosilicate glass tube has permanently attached, molded phenolic screw cap (size No. 24) with polyvinyl liner which fits commercial narrow…
-
HPTLC silica gel 60
MilliporeSigmaHPTLC plates deliver fast and quantitative analysis of complex samples for manual or automated use. EMD Millipore’s HPTLC silica plates work three times faster than conventional TLC plates – and they’re more sensitive. The particle sizes range in HPTLC is between 4-8µm, which creates a smoother…
-
Features IONEX-25 SA-Na: mixture of silica and a strongly acidic cation exchanger coated to polyester sheets IONEX-25 SB-AC: mixture of silica and a strongly basic anion exchanger coated to polyester sheets Both layers contain an inert organic binder. Recommended application:…
-
TLC Silica gel 60 F254
MilliporeSigmaEMD Millipore classical silica TLC plates are based on a combination of proven EMD Millipore silica gel 60 and the addition of a unique polymeric binder resulting in a very adherent and hard surface that will not crack or blister and even allow writing with a pensil on the surface without risk to…
-
TLC Silica gel 60 F254
MilliporeSigmaClassic silica TLC plates are based on a combination of proven EMD Millipore silica gel 60 and the addition of a unique polymeric binder resulting in a very adherent and hard surface that will not crack or blister and even allow writing with a pensil on the surface without risk to damage the layer.
-
SIL G Unmodified Standard Silica Layers for TLC
MACHEREY-NAGELSilica 60, specific surface (BET) ~ 500 m 2 /g, mean pore size 60 Å, specific pore volume 0.75 mL/g, particle size 5–17 µm; standard grade Thickness of layer for analytical plates 0.25 mm, for preparative plates 0.5 and 1 mm For 2 mm preparative layers a slightly coarser…
-
Nano-SIL C18 Octadecyl-Modified HPTLC Silica Layers
MACHEREY-NAGELFeatures Base material: Nano-silica 60, specific surface (BET) ~ 500 m2/g, mean pore size 60 Å, specific pore volume 0.75 mL/g, particle size 2–10 μm, pH stability 2–10 Partial (50%) or complete (100%) octadecyl modification, carbon content 7.5 and 14%, respectively…
-
TLC Silica Gel 60 F254 Multiformat Pre-scored to 5 x 10 cm
MilliporeSigmaPre-scored glass plates fold into smaller formats with just one easy snap of the fingers. HS Code: 3822 00 00
-
HPTLC Silica gel 60 F254
MilliporeSigmaPlates deliver fast and quantitative analysis of complex samples for manual or automated use. EMD Millipore’s HPTLC silica plates work three times faster than conventional TLC plates – and they’re more sensitive. The particle sizes range in HPTLC is between 4-8µm, which creates a smoother surface…
-
HPTLC Silica Gel 60 F254
MilliporeSigmaHPTLC plates deliver fast and quantitative analysis of complex samples for manual or automated use. EMD Millipore’s HPTLC silica plates work three times faster than conventional TLC plates – and they’re more sensitive. The particle sizes range in HPTLC is between 4-8µm, which creates a smoother…
-
TLC Kieselguhr F254
MilliporeSigmaPrecoated Kieselguhr or mixed Silica gel/Kieselguhr plates are only of small importance nowadays. Kieselguhr layers are used like cellulose layers for the TLC separation of polar and moderately polar substances. Polyamide, on the other hand , is used for the separation of flavonoids and other…
-
HPTLC Silica gel 60 F254 GLP
MilliporeSigmaThese plates feature individual laser coding for GLP applications. Designed for GLP applications, the tops of each of these plates bear an item, batch, and individual plate number. As a result, lab professionals can easily record and archive every plate they use. Based on proven EMD Millipore…
-
TLC Silica gel 60 with Concentrating Zone 20 x 2.5 cm
MilliporeSigmaThese plates allow users to quickly and easily apply any kind of sample, even large volumes of diluted samples. EMD Millipore concentrating zone plates are based on different adsorption properties of two adsorbents. The first is a large pore concentrating adsorbent where the samples are applied;…
-
-
TLC SILICA GEL 60 W F254S 25 GLASS PLATES 20 X 20 CM
MilliporeSigmaEMD Millipore classical silica TLC plates are based on a combination of proven EMD Millipore silica gel 60 and the addition of a unique polymeric binder resulting in a very adherent and hard surface that will not crack or blister and even allow writing with a pensil on the surface without risk to…
-
Cellulose MN 300 Native Fibrous Cellulose Layers for TLC
MACHEREY-NAGELFeatures Fiber length (95 %) 2–20 μm, average degree of polymerization 400–500 specific surface acc. to Blaine 15000 cm 2 /g ≤ 20 ppm Fe, 6 ppm Cu, 7 ppm P; dichloromethane extract ≤ 0.25% residue on ignition at 850°C ≤ 1500 ppm available as glass…
-
HPTLC SILICA GEL 60 RP-18 F254S 25 GLASS PLATES 10 X 10 CM
MilliporeSigmaRP modified plates serve two purposes: act as a pilot method for HPLC and allow to choose various solvent system for special separations. RP-modified silica layers from EMD Milliporeare well suited for many separation challenges that unmodified silica cannot overcome. These layers use aqueous…
-
TLC SILICA GEL 60 100 GLASS PLATES 2.5 X 7.5 CM
MilliporeSigmaEMDMilliporeclassical silica TLC plates are based on a combination of proven EMD Milliporesilica gel 60 and the addition of a unique polymeric binder resulting in a very adherent and hard surface that will not crack or blister and even allow writing with a pensil on the surface without risk to…
-
TLC SILICA GEL 60 RP-18 F254S 50 GLASS PLATES 5 X 20 CM
MilliporeSigmaRP modified plates serve two purposes: act as a pilot method for HPLC and allow to choose various solvent system for special separations. RP-modified silica layers from EMD Millipore are well suited for many separation challenges that unmodified silica cannot overcome. These layers use aqueous…
-
Nano-DURASIL Unmodified HPTLC Silica Layers
MACHEREY-NAGELFeatures Nano silica 60, specific surface (BET) ~ 500 m2/g, mean pore size 60 Å, specific pore volume 0.75 mL/g, particle size 2–10 µm Indicator: manganese activated zinc silicate with green fluorescence for short-wave UV (254 nm) Hard, water-resistant and wettable…
-
TLC Cellulose
MilliporeSigmaThese cellulose plates are used to analyze polar substances. An organic sorbent, cellulose is perfect for separating hydrophilic substances by partition chromatography. Typical applications include the analysis of amino acids, carbohydrates, and phosphates as well as nucleic acid and nucleic acid…
-
SIL G Unmodified Standard Silica Layers for TLC
MACHEREY-NAGELSilica 60, specific surface (BET) ~ 500 m 2 /g, mean pore size 60 Å, specific pore volume 0.75 mL/g, particle size 5–17 µm; standard grade Thickness of layer for analytical plates 0.25 mm, for preparative plates 0.5 and 1 mm For 2 mm preparative layers a slightly coarser…
-
Synonyms: TLC cards Silica gel
-
Silica Gel HLF UNIPLATES
Miles Scientific (Analtech)These are the most rugged silica gel plates available. They not only ease handling and sample application, but also permit the use of up to 80% water in the developing solvent without loss of adherence of the adsorbent layer to the glass plate. Organic binder plates are recommended for all TLC…
-
These plates allow users to quickly and easily apply any kind of sample, even large volumes of diluted samples. EMD Millipore concentrating zone plates are based on different adsorption properties of two adsorbents. The first is a large pore concentrating adsorbent where the samples are applied;…
-
TLC Silica Gel 60 RP-18 F254s
MilliporeSigmaRP modified plates serve two purposes: act as a pilot method for HPLC and allow to choose various solvent system for special separations. RP-modified silica layers from EMD Millipore are well suited for many separation challenges that unmodified silica cannot overcome. These layers use aqueous…
-
Baker-Flex'® Silica Gel Ib2-F 1 Pk
Avantor - J.T.Baker®Flexible TLC Sheet for laboratory, research or manufacturing use Baker-flex™ polyester-backed sheets can be easily cut to remove a section of the sheet when you need to isolate a sample component of particular interest. Sheet Size: 2.5 x 7.5 cm Sheets/Package: 200 …
-
Chromatography TLC Sprayers
SP Wilmad-LabGlassWhen using thin layer or paper chromatography (TLC), these borosilicate glass atomizers are used for spraying chromogenic reagents. Complete unit consists of spray head, flask, and LG-1004 clamp. The air inlet tube has an opening to release pressure and stop spraying. All joints are Standard Taper 24/40.
-
-
TLC LuxPlate® Silica gel 60 F254
MilliporeSigmaClassic silica TLC plates are based on a combination of proven EMD Millipore silica gel 60 and the addition of a unique polymeric binder resulting in a very adherent and hard surface that will not crack or blister and even allow writing with a pensil on the surface without risk to damage the layer.
-
Corning® 96 Well Strip Ejector
CorningDesigned to remove Stripwell™ strips from the egg crate holder
-
ProteoChrom® HPTLC Cellulose Plate
MilliporeSigmaWe’ve enhanced our ProteoChrom® plates to make separation highly efficient – especially when peptides and protein digests need to be analyzed. ProteoChrom® plates take performance to new levels. Applications are highly reproducible thanks to optimized separation and staining procedures. With…