23A00U199: Clear Zone adhesive free 96-well film Our 50µm thick clear polypropylene film has 96 adhesive free wells. Clear Polypropylene is laid over a white backing for high contrast and low cross talk. Using the two (2) end tabs and 96 circles for alignment makes it easy to quickly apply this film directly over wells. Dimensions comply with ANSI/SBS 1-2004 specifications (9mm on center) to allow for simultaneous multi-well pipetting. Film is solid but clear over wells allowing for good sample viewing. The lack of adhesive in well areas minimizes the chances of adhesive off gassing near samples. Film is removable, not reusable. Strong adhesive minimizes cross-contamination, spillage and evaporation; covered plates can be inverted and agitated without sample leakage. Do not store plates inverted. Dimensions: 122.00 x 81.00mm (with tabs removed) Recommended for temperatures from -40° to +120°C All ILP sealing films are manufactured in a cleanroom environment. They are tested and certified on a lot to lot basis to be free of RNase, DNase, DNA, and Pyrogen contamination.
23A00U200: Clear Zone Pre-Slit and adhesive free 96-well film Our Clear Zone Pre-Slit 50µm thick polypropylene film is the best choice for use with automation. The 96 adhesive free wells are pre-slit to allow for easy access with needles, probes, or pipette tips without damage or soiling. The lack of adhesive removes the chance of any off gassing of VOCs that might occur. Wells can be accessed multiple times. Clear polypropylene is bonded with a white backing for high contrast and low cross talk. Using the two (2) end tabs and 96 circles for alignment makes it easy to quickly apply this film directly over wells. Dimensions comply with ANSI/SBS 1-2004 specifications (9mm on center) to allow for simultaneous multi-well pipetting. Film is clear over wells allowing for good sample viewing. Film is removable, not reusable. Strong adhesive protects samples and minimizes cross-contamination. Do not invert plates as these seals are pre-slit. Dimensions: 122.00 x 81.00mm (with tabs removed) Recommended for temperatures from -40° to +120°C All ILP sealing films are manufactured in a cleanroom environment. They are tested and certified on a lot to lot basis to be free of RNase, DNase, DNA, and Pyrogen contamination.