Vacuum Trap System

…most advanced vacuum trap system. Ideal for protection of vacuum lines and scientists alike, Vactrap safely contains waste from supernatant removal, chemical separation, and cell or tissue culture media aspiration. Best of all, Vactrap comes ready to use--simply attach to your vacuum and begin your…

…advanced vacuum trap system. Ideal for protection of vacuum lines and scientists alike, VactrapXL safely contains waste from supernatural removal, chemical separation, and cell or tissue culture media aspiration. Best of all, VactrapXL™ comes ready to use; simply attach to your vacuum and…

Vacuum trap system protects gauge heads, like our 14034, and pumps from corrosive vapors and particle fouling. System consists of a Dewar flask, cold trap and inlet arm. High-vacuum stopcocks are used throughout. Gauge & inlet arm are Ace-Thred connections. Pump & manifold connections are o-ring…

…hooks that allow the trap to hang on the side of the RapidVap Vacuum System. Alternatively, the bracket serves as a stand to stabilize the glass container resting on a flat work surface. This trap may also be used with pre-2005 CentriVap Cold Traps. Liquid Trap prevents liquid from entering…

Used for freezing out undesired vapors in the vacuum system and also for use in conjunction with Dewar flasks.

Connections are 180º apart for easy installation into a variety of vacuum systems. Protects the mechanical pump from attack by corrosive vapors which can be condensed by using liquid nitrogen or dry ice/slurry mixtures.

Outlets are 180º apart for easy installation into a variety of vacuum systems. Protects the mechanical pump from attack by corrosive vapors which can be condensed by using liquid nitrogen or dry ice/slurry mixtures. Two-piece construction allows removal of condensate.

…parts Solvent resistant at boiling points under 100°C Portable System is powered by a 1/8 hp, corrosion-resistant, PTFE pump. All wettable parts, including the diaphragm and valves are PTFE. Vacuum level regulator and built-in dial guage allow easy control of pressure to prevent…

…contamination in vacuum systems. Placing a cold trap at the mouth of such a pump greatly lowers the risk that oil vapors will back stream into the vacuum cavity. Care should be taken when using a cold trap not to condense liquid oxygen (a light blue liquid) into the cold trap. Liquid oxygen is…

…no dry vacuum pump has before – the first practical alternative to oil-seal rotary vane pumps. ChemStar Dry automates High Performance vapor flow (to 150L/min) at working vacuum levels (0.08 to 10 torr). Chemical resistant, max. vacuum is 0.05 torr. Smart system control coordinates vacuum…

Twin chamber vacuum trap for double protection against undesired vapors in a vacuum system. Trap can be used in a two liter Dewar flask such as 12540-07. Distance from outside of one body to outside of other is approximately 97mm; height is 250mm. Inlet and outlet have serrated fittings; O.D. of…

The CentriVap Cold Trap collects evaporated liquid from a CentriVap Concentrator, protecting an accessory vacuum pump from the corrosive effects of vapors and fumes emitted from samples. Exclusive features include: brushed, stainless steel and glacier white, epoxy-coated steel exterior with blue…

…Universal Vacuum Systems, equipped with an easy to use, wide-mouth glass condensation flask. This single integrated unit combines an oil-free vacuum source and refrigerated vapor trap, and can be connected to any of the concentrators to provide a complete SpeedVac system. UVS450…

…entering the vacuum pump, where they would condense, contaminate vacuum pump oils and can cause corrosion. Whilst doing this task the cold trap further prevents vacuum pump oil from streaming back into the vacuum chamber thus preventing potential product hydrocarbon contamination. Cold traps also…

…SPD1030 and SPD2030 Vacuum Concentrators are fully integrated systems that combine concentrator, refrigerated cold trap, diaphragm pump and vacuum gauge in a single, compact unit. Convenience and Flexibility in two capacity ranges The Savant SpeedVac SPD1030 System is designed for medium…

…SPD1030 and SPD2030 Vacuum Concentrators are fully integrated systems that combine concentrator, refrigerated cold trap, diaphragm pump and vacuum gauge in a single, compact unit. Convenience and Flexibility in two capacity ranges The Savant SpeedVac SPD1030 System is designed for medium…

…both hands free for operation Unit and pump are virtually maintenance-free External post trap to neutralize ammonium hydroxide vapors Optional chemical traps and optional cartridges to trap radioactive chemicals to minimize concerns in handling hazardous fumes and chemicals. …

…from vacuum system          Trap:     Reduces risk of oil sucked back into the system This direct drive pump provides the best Performance/Cost Ratio available today. Comes complete with initial supply of High Vacuum Pump Oil. …

…direct-drive vacuum pumps. Dry Nitrogen Purge both degasses and cools the pump oil reducing the corrosion rate in the pump. Accessories (available on special order): Protective accessories may be needed for heavy corrosive gas loads which may contain particulates; Oil filtration system removes…

…gasket. Requires suitable external vacuum source such as water aspirator or vacuum pump. Accessory racks can be substituted for automatic samplers. Without vacuum source, vacuum tubing or vacuum trap. Normally, a 500 mL or larger vacuum filter flask is used as trap. Extraction columns are prepacked…

Modified version of 8750 series of vacuum traps, with side arm bent 90 degrees upward for easier attachment of vacuum tubing. For use with vacuum systems to capture undesirable vapors. Fits easily into Dewar flasks.

…contaminate and degrade vacuum pump oil with Thermo Scientific™ Savant™ Refrigerated Vapor Traps (RVT). The RVT safely recovers the solvent and reduces emissions of hazardous chemicals in the environment. Solvents are removed from samples during vacuum evaporation with a…

1229D81 - Buchi V-850/855 Vacuum Controller Valve combined with condensate trap and non-return valve with attachment for Rotavapor (not necessary with V-700/710 in stand-alone systems). 1229D82 - Buchi RC-81 remote control can be used to control the vacuum controller and the Rotavapor:…

…environments Four-stage filtering system removes particles (to 0.12µm) from exhaust system Made of cleanroom-compatible material, including electropolished stainless steel housing During the first and second vacuum stages, large particles are trapped in a disposable bag and a…

The CentriVap Vacuum Concentration System includes the following components: Acid-Resistant Benchtop Vacuum Concentrator with Glass Lid 7810016; Cold Trap 7811020; Clear Canister 7460900; Acid Insert 7814800; 12-13 mm Acid-Resistant Rotor 7455101; Glass Trap 7397605; and Vacuum Tubing and 6 Clamps.

The CentriVap Vacuum Concentration System includes the following components: Acid-Resistant Benchtop Vacuum Concentrator with Glass Lid, Cold Trap, Clear Canister, Acid Insert, 12-13 mm Acid-Resistant Rotor, Glass Trap, and Vacuum Tubing and 6 Clamps.

…aspirators. Select vacuum range 100 to 5 torr; flow range 22 to 201 l/min. For use with dry or aqueous vapor applications only. Includes Vacuum and Pressure Regulators and Gauges - simple monitoring and adjustment of vacuum level and delivery pressure. Inlet Water Trap - float ball rises to…

Turnkey wiped film system for precise distillations.  Complete system includes 2-liter Jacketed Fill Funnel, all temperature control of the glass jacketed fill funnel, main body, condensor, cold fingers and cold trap. Powerful PTFE wiper stirring, deep vacuum, and professional…

…Trap connects in series with a freeze dry system or vacuum evaporation system and vacuum pump to prevent contaminants from migrating into the vacuum pump. An insulated well, when dry ice and solvent are added, cools to approximately -75° C (-103° F). When used alone, Dry Ice Secondary Trap…

…Trap connects in series with a freeze dry system or vacuum evaporation system and vacuum pump to prevent contaminants from migrating into the vacuum pump. An insulated well, when dry ice and solvent are added, cools to approximately -75° C (-103° F). When used alone, Dry Ice Secondary Trap…

…the main trap assembly. Both traps can be isolated from the line for cleaning by the 0-12mm Chem-Vac™; Chem-Cap®; valves Spacing between the two traps is 175mm for easy placement of dewar flasks. Complete system consists of one 5-port vacuum/inert manifold, one pre-trap, one main trap…

…downstream with bubble traps. Traps feature ¼"-28 UNF(F) port and come with 10 µm PTFE filter. The high-flow trap features a vacuum port on the atmosphere (dry) side of the membrane. When vacuum is applied, the pressure differential between the system and atmosphere side increases…