Slide Heater

The Thermal Slide is a microscope slide temperature control system for upright microscopes consisting of a microscope slide carrier and microscope slide having an electrically conductive, optically transparent coating on the bottom surface that generates heat in the slide so that any specimen…

…necessary Dual heater convection system for excellent temperature control Process up to twenty (20) 3”x 1” glass microscope slide Includes slide tray and metal slide holder Easy-to-use control system Includes RapidFISH Slide Hybridizer, Slide Tray, Slide Holder …

…50 slides, it has the facility for drying slides in different orientations- across the drying support bars, angled from the bars, or flat without the bars. There is an On/Off switch and "Power On" white neon and "Heater On" amber neon indicators. The silicone rubber mat element heater provides…

…allow high-volume laminar flow perfusion. Both of these functions are incorporated into our patented Microaqueduct Slide (see drawing below). The surface of the Microaqueduct Slide, opposite the specimen side, is coated with an electrically conductive, transparent, thin film of Indium-Tin Oxide…

… There are several factors that make the Stable "Z" superior to traditional "stage heaters". When a material is heated it expands. This is why other “stage heaters induce thermal drift. However, within the heated core components of the Stable Z, there is a nodal plane…

Microaqueduct Slides – 1178J98 This slide is the heart of the FCS2 and FCS3 systems. The slide has an ITO coating on the opposite side of the glass where the cells are located when assmebled, which provides intrinsic heat directly to the cells. The slide has two "T" shaped…

…and allow high-volume laminar flow perfusion. Both of these functions are incorporated into our patented Microaqueduct Slide (see drawing below). The surface of the slide, opposite the specimen side, is coated with an electrically conductive transparent thin film of Indium-Tin Oxide (ITO) and…

…simultaneously opens slide shutter and applies test flame to sample at the turn of a knob. Bath and cover mechanisms are constructed of plated brass. Includes liquid bath with constant level overflow, brass test cup, plated brass thermometer ferrules and test flame reference bead. Heater is enclosed…

…used for yeast. The Media Depth Reducer is composed of a 0.5mm thick coverglass window mounted in a 22mm diameter stainless steel cylinder, which slides into a Delrin threaded receiver that is adjustable in the Z-axis by rotation of a metal outer ring that rests on the top of the dish. Coverslip…

…C). Temperature of the heater stabilizes at the set point (±15°F) within 3 to 5 minutes Two heater receptacles with heater door to accommodate heater pans. Ten aluminum heater pans are included Stainless steel support manifold with three control slide slots and perforations for…

…mechanism slides shutter open and applies test flame at the turn of a knob. Cover fits over brass test cup and includes pilot flame, test flame reference bead, built-in stirrer and plated brass thermometer ferrule. Electrically heated model is equipped with a 1000W nickel-chromium heater with…

…rapid and accurate temperature setting. An integral over-temperature protection system automatically tracks the set temperature and controls the heater in the event of a fault. Error codes are displayed if a fault has occurred or if the set temperature has been interrupted. An acrylic upwards…

…with wide raised rims. This means that less heat is needed to seal the thin rim plate in comparison to the wide rim plate. The pressure that the heater plate exerts during sealing is pre-set and cannot be adjusted. Plates that do not have any raised rims are not recommended for heat-sealing. …

…fluctuations in the distillation phase. Electric distillation and digestion heaters with curved ceramic bases to cradle 500 or 800 ml Kjeldahl digestion flasks. Individual infinite-control knobs for electric heaters with variable input from 20-100% capacity • Chemical-resistant CPVC fume…