Pressure Vessel

Compare Tool

Select up to 3 products

Pressure Vessel
1 - 32 of 136
Sort
View
Show
  • Pressure Reaction Vessels And Accessories

    Andrews Glass Co.

    pressurization or contents release, allowing many test parameters Reaction vessels are available in three standard capacities: 3 oz., 6 oz. and 12 oz. CAUTION: safety precautions should be used with glass under pressure. Maximum safe pressure depends on service conditions. Pressure

  • Resin Reaction Flasks And Supplies

    Corning

    …Clamping which is positive and quick-acting; easier to apply and remove than two-piece clamps Spring-action lugs which cannot crack flange Fiber knobs which are heat-resistant Ribbed Teflon gaskets, which reduce clamp pressure required for complete seal Maximum temperature 200°C

  • SYNTHWARE Round Bottom Pressure Vessels

    Kemtech America

    Pressure Vessel, Round Bottom, Synthware, Capacity: 75, 15, or 350mL available, OD: 46-80mm available, Length: 129-162mm available, GL Thread: 15 or 25 available.

  • Pressure Filter Holders with Reservoir, Stainless Steel

    Advantec MFS

    …need for a pressure vessel Filter small batches of liquid Available in type 304ss or 316ss These quality stainless steel holders are designed for filtering small batches of liquid without having to use a separate pressure vessel. There are separate ports for pressurizing the reservoir…

  • HEPA-Cap Disposable Inline Filter

    GE Healthcare

    …Media is laminated hydrophobic-treated glass microfiber. To ensure clean air passing in and/or out of vessels, the glass microfiber filter media provides high flow rates with low pressures. HEPA-CAP 36 has a 625 cm 2 filter area and stepped hose barb connections for 1/4" to 3/8" (8…

  • Pressure Tubes

    Ace Glass

    Ace Glass pressure tubes are the premier glass pressure vessels in the industry. our tubes are rated at 150psi at as much as 120 degrees C. Due to varying conditions, Ace cannot guarantee glass vessels from breakage under pressure. Observe all laboratory safety procedures including working behind a…

  • XX6700P01

    MilliporeSigma

    Dispensing pressure vessel, 1 gallon Dispensing pressure vessels hold liquid for filtration through Millipore pressure-operated filter holders when connected to an external pressure source. Type 316 stainless-steel body and fittings; Viton gaskets and O-rings; molded neoprene rubber…

  • Manometer With Needle Valve

    Buchi

    Manual vacuum regulation can also be a very cost-effective solution. Air is drawn in through a fine regulation valve and the resulting vacuum is set. A manometer displays the pressure. The recommended Woulff bottle acts as a buffer vessel and condensate trap.

  • Pressure Reactor, One-Piece, Plain Flask

    Ace Glass

    pressure reactor system designed to perform low to moderate positive pressure reactions, synthesis and catalysis. Reactor capacities range from 500ml to 5000ml and use Ace-Threds to achieve a leak-tight system. One-piece design features a 25mm center opening and has a higher allowable pressure

  • SYNTHWARE Heavy Wall Cylindrical Pressure Vessels

    Kemtech America

    Pressure Vessel, Heavy Wall, Cylindrical, Synthware, Capacity: 15-120mL available, GL Thread Size: 15, Vessel has an internal thread for use with PTFE bushing, O-ring is positioned above the thread for inproved sealing.

  • Pressure Vessel Accessory Kit

    MilliporeSigma

    Accessories for filter holders for sample preparation Includes pressure relief valve, pressure gauge, hex nipple, ball valve, quick-release nipple, hose adapter. Diameter: 6.3 mm (0.25 in.) (I.D.)

  • Pressure Vessels, Tubes & Bottles

    Ace Glass

    Ace Glass pressure tubes and bottles are the premier glass pressure vessels in the industry. Flat-bottomed bottles are rated at 60psi at room temperature while our tubes are rated at 150psi at as much as 120 degrees C. Due to varying conditions, Ace ca

  • Pressure Tubes

    Ace Glass

    Ace Glass pressure tubes are the premier glass pressure vessels in the industry. our tubes are rated at 150psi at as much as 120 degrees C. Due to varying conditions, Ace cannot guarantee glass vessels from breakage under pressure. Observe all laboratory safety procedures including working behind a…

  • Cement Autoclave

    Boekel

    …supporting frame and enclosed in a heat insulated metal housing. The unit is designed to handle pressure in the 60-350 psi (0.4 -2.4 MPa) range and consists of steam vessel, pressure regulator, pressure gauge (0-600psi), air vent valve, power switches, and a safety pop valve set at 350 psi. …

  • Pressure Tubes, Sample Port

    Ace Glass

    pressure tubes in the world, rated at 150 psig at 120 degrees C. Featuring a #7 Ace-Thred sample port, these tubes offer the convenience of sampling while remaining connected to the researcher's apparatus. Due to varying conditions, Ace cannot guarantee glass vessels from breakage under pressure,

  • Pressure Reactor, One-Piece, Jacketed Flask

    Ace Glass

    pressure reactor system designed to perform low to moderate positive pressure reactions, synthesis and catalysis. Reactor capacities range from 500ml to 5000ml and use Ace-Threds to achieve a leak-tight system. One-piece design features a 25mm center opening and has a higher allowable pressure

  • Manifold, Pressure Relief

    Ace Glass

    …Series™ stand via the 12841 vertical rod assembly, the pressure relief manifold inlet/outlet set will help protect the glass vessel from breakage due to an excessive pressure differential exerted by the thermal transfer fluid while the vessel is isolated or disconnected from the circulator.…

  • Dispensing Pressure Vessel, 10 L

    MilliporeSigma

    … Connections, Inlet/Outlet: 1/4 in. NPTF elbow fittings for inlet and outlet (labeled); 1/4 in. NPTF for pressure gauge and vent/relief valve attachment. Maximum Inlet Pressure, bar (psi): 6.9 bar (100 psi) Height: approx. 14 inches Materials of Construction: 316 stainless…

  • Pressure Reactor, Two-Piece, Jacketed Flask

    Ace Glass

    Complete, two-piece, jacketed flask, pressure reactor system designed to perform low to moderate positive pressure reactions, synthesis and catalysis. Reactor capacities range from 500ml to 5000ml and use Ace-Threds to achieve a leak-tight system. Two-piece (flanged flask and head) design allows the…

  • Funnel Addition, Pressure Equalizing, Jacketed

    Ace Glass

    Jacketed version of 7297 series addition funnels. Jacket runs from shoulder at top of vessel to above the PTFE stopcock. Has size D hose barbs for 3/8in ID tubing. Pressure equalizing arm runs from top of vessel to just below the PTFE stopcock. Graduat

  • Pressure Reactor, One-Piece, Jacketed, Bottom Outlet

    Ace Glass

    pressure reactor system designed to perform low to moderate positive pressure reactions, synthesis and catalysis. Reactor capacities range from 500ml to 5000ml and use Ace-Threds to achieve a leak-tight system. One-piece design features a 25mm center opening and has a higher allowable pressure

  • Infectious substance shipper with tubes

    Thermosafe

    …packaging, absorbent material for full capacity of blood, corrugated carton and step-by-step packing instructions Infecon® shippers include pressure vessel with stop-lock lid, compartmentalized bubble pouch, 50 ml absorbent sheet, corrugated outer carton with required markings, shipper's…

  • Pressure Reactor, One-Piece, Unjacketed, Bottom Outlet

    Ace Glass

    …featuring a one-piece, unjacketed, pressure vessel with a combination Ace-thred valve and 28/15 o-ring ball joint bottom outlet. Vessel top has a 25mm Ace-thred center neck and various multi-neck configurations. System is designed to perform positive pressure reactions at up to 45 psi at 100 degrees…

  • Sanitary Pressure Filter Holders, Stainless Steel

    Advantec MFS

    …Other materials are available. Seal membrane by hand tightening locking wing nuts. Advantec offers a complete family of large pressure holders and pressure vessels. Holders are available with PTFE coating by special order. Please Note: ALL Advantec items have a maximum 48 hour cancellation…

  • Cooling Circulator for Variable Bath Vessels

    Huber USA

    …respective bath sizes can be adapted for optimal results. Furthermore, the pump pressure for external applications can be set and controlled using the menu control with an optional pressure sensor. Insulated bath vessels are available in stainless steel as an accessory in three standard sizes or can…

  • Flask, Pressure, Round Bottom

    Ace Glass

    Round bottom, heavy wall, pressure rated flask. All flasks come complete with a solid PTFE plug seal with front seal FETFE o-ring for better containment of product. Vessels are tested at 1.5x for a working pressure rating at 60PSI at 120°C. Flasks

  • Turbidity Mtr. Lab IR 555Ir

    WTW

    …all also included in the documentation of the measurements. Continuous flow-through measurements are possible up to a pressure of 4 bar with FLOW-THRU-TURB vessel. Come complete with 4 AMCO Clear® standards for calibration up to 4000 NTU. For applications up to 10 000 NTU a further standard…

  • Stopper Pressure Relief

    Glas-Col

    …glass. The Snorkel Stopper features a one-way check valve that automatically relieves gas pressure. The valve releases pressure of more than 1 pound and prevents direct air contact with the vessel. The shape of the stopper allows manual or machine shaking and avoids solution leakage. For…

  • 2-Part Secondary Pressure Vessel

    Saf-T-Pak

    For Category A, certified for use with the STP-110 & STP-310. System Components: Quantity – 50/Case Inner leak proof polybag – 8 1/2 x 10 1/2” ID Tyvek outer envelope – 7 1/2 x 9 1/2” OD

  • Seal for Pressure Vessel M & H

    PerkinElmer

    Lip type seal made of PTFE-TFM with venting system. Fits both pressure vessels of the Rotor 16, vessel MF100 and HF100.

  • PTFE 2 mL Weighing Cup for Std/High Pressure Digestion Vessel

    PerkinElmer

    For use in Standard 75 mL (40 Bar) or High Pressure 100 mL (100 Bar) Digestion Vessel, qty. 1.

  • PTFE 2 mL Weighing Cup for Std/High Pressure Digestion Vessel

    PerkinElmer

    For use in Standard 75 mL (40 Bar) or High Pressure 100 mL (100 Bar) Digestion Vessel, quantity- 16.

Compare Tool

Select up to 3 products

Please Log In

Don't have an Account? Create one now.