Protector XL Floor-Mounted (Walk-In) Laboratory Hoods have panel liners that may be constructed of a variety of corrosion-resistant materials and supplied in three depths to meet individual installation and application requirements.
They are suitable for general chemistry applications and accommodate oversized apparatus. Widths of up to 16 feet are offered.
Features
- By-pass airflow design
- Dry powder, glacier white epoxy-coated steel exterior
- Chemical-resistant molded composite panel liner and adjustable upper and lower baffles with flame spread less than 25 per ASTM E-84
- Removable front and side panels and exterior and interior service access panels for access to plumbing and electrical wiring
- Pre-wired instant-start T8 fluorescent lighting, light and blower switches for 115 volt, 60 Hz operation
- Tempered safety glass vertical-rising sashes framed with PVC (4', 5' and 6' models) or epoxy-coated aluminum (8' models)
- Tempered safety glass horizontal-sliding sashes with epoxy-coated aluminum frames and sash tracks (8', 10', 12', 16' models)
- Factory prepared for up to eight service fixtures including two gooseneck faucets
- Factory prepared for up to four electrical duplex receptacles
- Shipped in multiple sections, top and bottom
- Epoxy-coated, stainless steel 12.81" ID exhaust connection(s)
- ETL listed
Options
- 4', 5', 6', 8', 10’, 12’, 16’ widths
- Interior depths of 30”, 36” and 48”
Rear Finish Panel Kits
Glacier white powder-coated steel panel hides hood's interior components on the rear to provide finished appearance. Recommended when hood is mounted on a casework island w/ back exposed. Adds 1.5" to overall depth of Floor-Mount hoods.