• For determining the amount of dilution in engine crankcase oils when gasoline has been used as the fuel
• Graduated from 0 to 5 mL in 1/10 mL divisions
• With Standard Taper 24/40 inner joint at bottom
• For ASTM Standard D 322; ANSI method Z11.29; API standard 524; and Federal Test Method Standard
No. 791, method 3001.5
• For determination of water in petroleum or bituminous materials in Barrett test B-2
• Meets ASTM Standard D 95
• With Standard Taper 24/40 outer member at top
and Standard Taper 24/40 inner member at
bottom of side arm
• Graduated from 0 to 3 mL in 1/5 mL,
and 3 to 20 mL in 1/2 mL divisions,
with Standard Taper 1 drain stopcock
• With Standard Taper24/40 outer member at top and
Standard Taper 24/40 inner member at bottom of
side arm
• In accordance with ASTM Standards
E 123 and D 95 for water in petroleum products
• Graduated from 0 to 1 mL in 1/10 mL; maximum scale error: 0.05 mL; graduations over 1 mL in 1/5 mL; maximum scale error: 1/10 mL. 10 mL trap is approx. 237 mm long; 25 mL trap is aprox. 317 mm long.