Trap provides protection of vacuum gauges from particulates which contaminate the mercury when the gauge is vented to the atmosphere. Supplied packed with glass wool. Hose connections have a 9mm OD at the middle serration.

Similar to the AF-0450 5-port line, except that the line is constructed using 0-4mm Chem-Vac™; Chem-Cap®; valves (A) instead of the CG-468-02 greased glass stopcocks on all of the 4-ports. The end cap on the vacuum line is a #30 o-ring joint while the inert gas line has a #9 o-ring joint…

Dual trap assembly for use with AF-0060 or AF-0061 manifolds. Pre-trap (B) is 51mm OD x 250mm long with 28/15 polished socket joints to connect the line shut off adapter (A) to the main trap stopper assembly (C) which has 28/15 o-ring ball joints. The main trap (D) is constructed using a 57mm flat…

Similar to CG-1032, but with joints of non-similar sizes at the upper and lower portion of the adapter. Dimensions are the same as the CG-1032.

Adapter used to construct a simple moisture trap. Add a condenser to the top outer joint and a graduated funnel to the lower inner joint. Adapters with larger center to center spacing can be used with process reactors and larger flasks up to 50L.

Micro impinger designed for sampling of small volumes of air at low jet velocity, as per EPA Method 6. Impinger bottle is graduated from 5 to 30mL in 5mL subdivisions. Both the bottle and stopper have 24/40 standard taper joints. The nozzle being replaced with an extra coarse fritted gas dispersion…

Outer joint having a tubulation sealed at the midpoint of the ground portion, and a corresponding hole drilled in the inner joint permitting venting of the side tube when the inner joint is turned to the proper position. Both of the 19/38 sizes are compatible with Buchi Rotary Evaporators. Part…

Adapter is placed above flask to prevent carry-over of reactions which have a tendency to foam. With top standard taper outer and lower inner joints, both being the same size.

Modified Dean-Stark trap allows for more efficient cooling and separation of the azeotrope during distillation. Graduated from 0 to 10ml in 0.2mL subdivisions. **Design suggested by Dr. Craig Merlic, University of California, Los Angeles, California

Vapor tube/bump trap adapter is designed to be used with the Büchi® R-200/205 rotary evaporators. This adapter combines a vapor tube adapter and a bump trap. Trap has an extra coarse fritted disc sealed between the lower inner joint and the top flange. Adapters have a 50mm OD top flange…

Adapter has a coarse frit sealed between the #15 o-ring joint and the standard taper inner joint. Frit permits filtration of large particles before introduction into the flask and also serves as a bump trap for reactions being performed in flasks while connected to the manifold. Each adapter is…