TLC Plates

Compare Tool

Select up to 3 products

1 - 32 of 190
Sort
View
Show

Greiner

  • Cellulose plates (TLC and HPTLC)

    MilliporeSigma

    For analysis of polar substances The organic sorbent cellulose is particularly suitable for the separation of hydrophilic substances by partition chromatography. EMD Millipore cellulose plates include classical TLC grade or HPTLC plates for demanding high-performance separations: TLC…

  • TLC Developing Tank

    DWK Life Sciences (Kimble)

    Constructed of sturdy molded glass bricks Withstands regular use for many years The tank’s clear sides allow for visual inspection of TLC plates up to 20 x 20 cm size. The top of the tank is ground flat to match the lids and the edges are beveled to remove any sharp edges. The bottoms are…

  • Rectangular Developing Tank

    General Glass Blowing

    Beveled inside and outside to remove any sharp edges Raised ridge midway on the inside ends and bottom for developing two 20 x 20 cm plates or the equivalent Inside dimensions: 27 x 7 x 26 cm Supplied with flat glass lid, 30 x 10 x 3 cm Molded glass block of clear glass with…

  • Thomas Glass Sprayer

    Thomas®

    Provides uniformly fine mist or spray, required for paper chromatographic determination Conveniently located vent permits instantaneous control of spray Borosilicate glass tube has permanently attached, molded phenolic screw cap (size No. 24) with polyvinyl liner which fits commercial narrow…

  • Corning® High-Content Imaging Glass Bottom Microplates

    Corning

    High optical-quality glass bottom, black microplates are ideal for performing high-content cell-based assays using imaging systems. The glass bottom provides a flat and optically clear surface that reduces autofocus time, increases throughput and is ideal for cell growth. High optical quality…

  • TC-Treated Cell Culture Plates

    NEST Scientific USA

    Nest cell culture plates have round edges for better handling. Low profile, low-evaporation lid design assure uniform growth. Small feet on the bottom corners of each plate eliminate scraping of the microscope lens. Sterilized by E-beam High clarity, 100% virgin polystyrene Vacuum…

  • TLC Reagent Sprayers

    DWK Life Sciences (Kimble)

    Provides a uniform spray mist of visualization reagents for both thin layer and paper chromatography Borosilicate glass Handles all standard TLC spray reagents and most corrosive liquids Creates consistent spray patterns that are free of damaging droplets The connection between the sprayer…

  • TLC LuxPlate® Silica gel 60 F254

    MilliporeSigma

    Classic silica TLC plates are based on a combination of proven EMD Millipore silica gel 60 and the addition of a unique polymeric binder resulting in a very adherent and hard surface that will not crack or blister and even allow writing with a pensil on the surface without risk to damage the layer.

  • 10 cm Developing Tank

    General Glass Blowing

    Flat ground top is beveled on the inner and outer rim Ground flat bottom for stability Holds two 10 x 10 cm plates or four 5 x 10 cm plates Thin-Line units allow for faster and more uniform solvent saturated atmosphere and therefore require less solvent. Inside dimensions: 12 x 6.4…

  • Reversed Phase Octadecyl Silanized Silica Gel UNIPLATES

    Miles Scientific (Analtech)

    These reversed phase TLC plates have been manufactured to be greater than 50% and less than 100% silanized. Because of this they are hydrophobic, but wettable. Features: 14% carbon content Acid stable (UV254) fluorescent indicator Glass backing 250um coating thickness 25…

  • Latch-Lid Chromatotank Unit

    General Glass Blowing

    Clear glass sides allow unobstructed visual inspection of contents Tank is ground flat to match ground glass lid. Beveled inside and outside to remove any sharp edges. Holds two 20 x 20 cm plates or four 10 x 20 cm plates. Latching device holds the matching ground glass surfaces of the lid…

  • 10 cm Latch-Lid Chromatotank

    General Glass Blowing

    Requires less solvent to maintain equilibrium Gives excellent retention of solvent saturated chamber Holds two 10 x 10 cm plates The smaller cubic inch chamber allows for a faster and more uniform solvent-saturated atmosphere. Single molded tank has a flat ground top, beveled for…

  • TLC Silica gel 60 F254

    MilliporeSigma

    Classic silica TLC plates are based on a combination of proven EMD Millipore silica gel 60 and the addition of a unique polymeric binder resulting in a very adherent and hard surface that will not crack or blister and even allow writing with a pensil on the surface without risk to damage the layer.

  • TLC Silica Gel 60 RP-18 F254s

    MilliporeSigma

    RP modified plates serve two purposes: act as a pilot method for HPLC and allow to choose various solvent system for special separations. RP-modified silica layers from EMD Millipore are well suited for many separation challenges that unmodified silica cannot overcome. These layers use aqueous…

  • HPTLC SILICE GEL 60 RP-8 F254S 25 GLASS PLATES 10 X 10 CM

    MilliporeSigma

    RP modified plates serve two purposes: act as a pilot method for HPLC and allow to choose various solvent system for special separations. RP-modified silica layers from EMD Milliporeare well suited for many separation challenges that unmodified silica cannot overcome. These layers use aqueous…

  • TLC Aluminium Oxide 60 F254, Basic

    MilliporeSigma

    Aluminiumoxide plates are used to analyze basic and neutral compounds at different pH levels. Depending on the pH range in question, professionals can choose between two kinds of aluminum oxide plates. Under aqueous conditions, basic aluminum oxide plates are best for separating basic compounds,…

  • SIL G Unmodified Standard Silica Layers for TLC

    MACHEREY-NAGEL

    Silica 60, specific surface (BET) ~ 500 m 2 /g, mean pore size 60 Å, specific pore volume 0.75 mL/g, particle size 5–17 µm; standard grade Thickness of layer for analytical plates 0.25 mm, for preparative plates 0.5 and 1 mm For 2 mm preparative layers a slightly coarser…

  • CHROMAFIL® MULTI 96 filter plates

    MACHEREY-NAGEL

    Features 96-well polypropylene plates for simultaneous filtration of 96 samples Advantages of this high-throughput system: Economical by saving time and solvent Minimized dead volume (≤ 40 µL) Use of multi-channel pipettors facilitates liquid transfer steps Readily…

  • RP-18 W/UV254 Octadecyl-Modified HPTLC Silica Layers

    MACHEREY-NAGEL

    Features Base material: silica 60, specific surface (BET) ~ 500 m2/g, mean pore size 60 Å specific pore volume 0.75 mL/g particle size 2–10 μm for preparative plates (1 mm thickness of layer) standard silica 60 particle size 5–17 µm pH stability…

  • HPTLC Silica gel 60 F254

    MilliporeSigma

    Plates deliver fast and quantitative analysis of complex samples for manual or automated use. EMD Millipore’s HPTLC silica plates work three times faster than conventional TLC plates – and they’re more sensitive. The particle sizes range in HPTLC is between 4-8µm, which creates a smoother surface…

  • TLC SILICA GEL 60 RP-18 F254S 50 GLASS PLATES 5 X 20 CM

    MilliporeSigma

    RP modified plates serve two purposes: act as a pilot method for HPLC and allow to choose various solvent system for special separations. RP-modified silica layers from EMD Millipore are well suited for many separation challenges that unmodified silica cannot overcome. These layers use aqueous…

  • Glass-Backed Analytical TLC Plates

    Miles Scientific (Analtech)

    This TLC plate can be developed using purely organic, organic/aqueous, and purely aqueous mobile phases. Due to this these plates have been used in numerous applications in normal phase chromatography as well as reversed phase chromatography. Common applications include the analysis of active plant…

  • ProteoChrom® HPTLC Cellulose Plate

    MilliporeSigma

    We’ve enhanced our ProteoChrom® plates to make separation highly efficient – especially when peptides and protein digests need to be analyzed. ProteoChrom® plates take performance to new levels. Applications are highly reproducible thanks to optimized separation and staining procedures. With…

  • Rectangular Developing Chambers

    General Glass Blowing

    The single most useful chamber for the TLC laboratory is a sturdy, molded-glass block of clear glass with flat surface walls, ground lip of uniform flatness, beveled inside and outside to remove any sharp edges. There is a raised ridge midway on the inside ends and bottom of the jar. Inside…

  • SIL G Unmodified Standard Silica Layers for TLC

    MACHEREY-NAGEL

    Silica 60, specific surface (BET) ~ 500 m 2 /g, mean pore size 60 Å, specific pore volume 0.75 mL/g, particle size 5–17 µm; standard grade Thickness of layer for analytical plates 0.25 mm, for preparative plates 0.5 and 1 mm For 2 mm preparative layers a slightly coarser…

  • HPTLC Silica gel F254 GLP

    MilliporeSigma

    Features individual laser coding for GLP applications. Designed for GLP applications, the tops of each of these plates bear an item, batch, and individual plate number. As a result, lab professionals can easily record and archive every plate they use. Based on proven EMD Millipore silica found in…

  • TLC Silica gel 60 RP-2

    MilliporeSigma

    RP modified plates serve two purposes: act as a pilot method for HPLC and allow to choose various solvent system for special separations. RP-modified silica layers from EMD Millipore are well suited for many separation challenges that unmodified silica cannot overcome. These layers use aqueous…

  • HPTLC Cellulose

    MilliporeSigma

    Cellulose plates are used to analyze polar substances. An organic sorbent, cellulose is perfect for separating hydrophilic substances by partition chromatography. Typical applications include the analysis of amino acids, carbohydrates, and phosphates as well as nucleic acid and nucleic acid…

  • HPTLC LiChrospher® Silica gel 60 RP-18 WF254s

    MilliporeSigma

    Unique HPTLC Lichrospher® plates are the first thin layer chromatography plates based on spherical silica particles. They offer the ultimate in thin layer chromatography performance and speed enabling high throughput analysis of complex samples. HS Code: 3822 00 00

  • TLC Silica gel 60 F254

    MilliporeSigma

    EMD Millipore classical silica TLC plates are based on a combination of proven EMD Millipore silica gel 60 and the addition of a unique polymeric binder resulting in a very adherent and hard surface that will not crack or blister and even allow writing with a pensil on the surface without risk to…

  • TLC Aluminium Oxide 60 FF254, Neutral

    MilliporeSigma

    Aluminiumoxide plates are used to analyze basic and neutral compounds at different pH levels. Depending on the pH range in question, professionals can choose between two kinds of aluminum oxide plates. Under aqueous conditions, basic aluminum oxide plates are best for separating basic compounds,…

  • UV lamp 254 nm

    MilliporeSigma

    For Thin Layer Chromatography

Compare Tool

Select up to 3 products

Please Log In

Don't have an Account? Create one now.