Spargers have 3 connections Agilent Technologies products are intended for sale/shipment within the US only. International customers should contact their local Agilent Technologies distributor to place orders for Agilent Technologies products.

The Agilent Technologies flangeless nuts and ferrules is suitable for use with is suitable for use with chromatography system models. This product is only available to U.S. Domestic Customers. For research use only, not to be used in diagnostic procedures.

The Agilent Technologies tubing cutter is made to cut up to 1/16 Inch thick stainless steel surfaces. Application: For 1/16 in stainless steel tubing This product is only available to U.S. Domestic Customers. For research use only, not to be used in diagnostic procedures.

Agilent Technologies products are intended for sale/shipment within the US only. International customers should contact their local Agilent Technologies distributor to place orders for Agilent Technologies products.

The gold seal forms a leak-free seal with the bottom of the inlet body and column ferrule to minimize both sample contamination and sample loss. Even small leaks in the split/splitless injection port can reduce system sensitivity, cause poor signal-to-noise ratio, increase column bleed, and even…

Agilent Technologies products are intended for sale/shipment within the US only. International customers should contact their local Agilent Technologies distributor to place orders for Agilent Technologies products.

This kit contains: 5mL x 0. 63mm outer diameter syringe 2mL clear sample vials (144) 2mL amber sample vials (100) blue crimp caps with septa (100) green crimp caps with septa (100) red crimp caps with septa (100) septa for waste/wash vials (100) crimper - 11mm decapper - 11 mm …

The Agilent Technologies headspace sampler transfer line nut fitting is suitable for use with G3520A transfer line interface accessory. Application: For G3520A Transfer Line Interface Accessory This product is only available to U.S. Domestic Customers. For research use only, not to be…

The Agilent Technologies 1 Liter sample bag is suitable for research and laboratory use. It is made of tedlar-polyvinyl fluoride (PVF) material which is chemical and solvent resistant. This product is only available to U.S. Domestic Customers. For research use only, not to be used in…

Agilent Technologies products are intended for sale/shipment within the US only. International customers should contact their local Agilent Technologies distributor to place orders for Agilent Technologies products.

The gold seal forms a leak-free seal with the bottom of the inlet body and column ferrule to minimize both sample contamination and sample loss. Even small leaks in the split/splitless injection port can reduce system sensitivity, cause poor signal-to-noise ratio, increase column bleed, and even…

Standard ECD makeup gas adapter (2715K81) includes one each of 2714C94 and 2714C95. Electron Capture Detector Sample (2713Y08) is used for the HP 5880, 5890 and 6890 with an ECD. Solution of 33 pg/mL (0.033 ppm) (w/v) each of lindane and aldrin in isooctane. Three 0.5 ml ampules. The Micro ECD…

The analytical technique known as thermal desorption (TD) provides the ability to measure volatile contaminants in air, toys, building materials, car cabins, and food. When the TD systems from Markes International are combined with Agilent GC and GC/MS systems, the results meet current requirements…

The Agilent Technologies SimDist (D2887E) hazardous calibration sample is suitable for research and laboratory use. This product is only available to U.S. Domestic Customers. For research use only, not to be used in diagnostic procedures.

Agilent Technologies products are intended for sale/shipment within the US only. International customers should contact their local Agilent Technologies distributor to place orders for Agilent Technologies products.

The Agilent Technologies water reservoir is often used for smooth functioning of system. This product is only available to U.S. Domestic Customers. For research use only, not to be used in diagnostic procedures.

The Agilent Technologies male fitting is often used for smooth functioning in the system. This product is only available to U.S. Domestic Customers. For research use only, not to be used in diagnostic procedures.

The VistaLab Technologies ali-Q™ replacement membrane filter is compatible for use with aliquoting pipette controllers. You can choose ideal replacement filter accessory which ensures smooth functioning. It is made of PTFE material, which ensures durability and long lasting life.

Agilent Technologies products are intended for sale/shipment within the US only. International customers should contact their local Agilent Technologies distributor to place orders for Agilent Technologies products.

Battery: LiFePO4 6. 4 Volt Rated 1500 Charge Cycles Tested to EN62133 and UN DOT Very low self-discharge Direct plug connection to board PTC’s integral to battery Crimper can operate while battery is charging. Motor: Stall torque 1400 g cm. Control Buttons: Top-mounted keypad…

Stainless Steel Nut, Size: 1/8in, Pkg 5

The Agilent Technologies FPD+ exit tube assembly is suitable for use with chromatography system models. This product is only available to U.S. Domestic Customers. For research use only, not to be used in diagnostic procedures.

The Agilent Technologies agilent syringe plunger is made from solid stainless steel material and is compatible to use with CTC HPLC samples. Application: For CTC HPLC, Replacement for 10 µL 8010-0445 This product is only available to U.S. Domestic Customers. For research use only, not to…

The Agilent Technologies valco loop rotor is often used for smooth functioning in the system. This product is only available to U.S. Domestic Customers. For research use only, not to be used in diagnostic procedures.

Agilent Technologies products are intended for sale/shipment within the US only. International customers should contact their local Agilent Technologies distributor to place orders for Agilent Technologies products.

The Agilent 5 mL sample loop made of polyetheretherketone is ideal for AQUATek 100. Application: For AQUATek 100 This product is only available to U.S. Domestic Customers. For research use only, not to be used in diagnostic procedures.

The Agilent Technologies FPD ignitor cable is suitable for use with 6850 and 6890 gas chromatography systems. Application: For Used With Series 6850 & 6890 Gas Chromatography Systems This product is only available to U.S. Domestic Customers. For research use only, not to be used in…

The Agilent Technologies 26 mL glass barrel with decal, is often used for smooth functioning of chromatography system models. This product is only available to U.S. Domestic Customers. For research use only, not to be used in diagnostic procedures.

Agilent Technologies products are intended for sale/shipment within the US only. International customers should contact their local Agilent Technologies distributor to place orders for Agilent Technologies products.

The analytical technique known as thermal desorption (TD) provides the ability to measure volatile contaminants in air, toys, building materials, car cabins, and food. When the TD systems from Markes International are combined with Agilent GC and GC/MS systems, the results meet current requirements…

Liner O-rings are used to form a proper seal around the outside of the inlet liner between the inlet weldment and the turn-top. O-rings are composed of either graphite or fluorocarbon material, Graphite O-rings are used when operating inlet temperatures exceed 350°C. Agilent fluoroelastomer or…

Agilent Technologies products are intended for sale/shipment within the US only. International customers should contact their local Agilent Technologies distributor to place orders for Agilent Technologies products.