TLC Plates

TLC Plates & Sheets, TLC Plates, Plates

Compare Tool

Select up to 3 products

All Products

Plates TLC Plates TLC Plates & Sheets

1 - 32 of 156
Sort
View
Show

Greiner

  • TLC Reagent Sprayers

    Kimble

    Provides a uniform spray mist of visualization reagents for both thin layer and paper chromatography Borosilicate glass Handles all standard TLC spray reagents and most corrosive liquids Creates consistent spray patterns that are free of damaging droplets The connection between the sprayer…

  • Cellulose plates (TLC and HPTLC)

    MilliporeSigma

    For analysis of polar substances The organic sorbent cellulose is particularly suitable for the separation of hydrophilic substances by partition chromatography. EMD Millipore cellulose plates include classical TLC grade or HPTLC plates for demanding high-performance separations: TLC…

  • Silica Gel HL UNIPLATES

    Miles Scientific (Analtech)

    These are the most rugged silica gel plates available. They not only ease handling and sample application, but also permit the use of up to 80% water in the developing solvent without loss of adherence of the adsorbent layer to the glass plate. Organic binder plates are recommended for all TLC…

  • TC-Treated Cell Culture Plates

    NEST Scientific USA

    Nest cell culture plates have round edges for better handling. Low profile, low-evaporation lid design assure uniform growth. Small feet on the bottom corners of each plate eliminate scraping of the microscope lens. Sterilized by E-beam High clarity, 100% virgin polystyrene Vacuum…

  • Thomas Glass Sprayer

    Thomas®

    Provides uniformly fine mist or spray, required for paper chromatographic determination Conveniently located vent permits instantaneous control of spray Borosilicate glass tube has permanently attached, molded phenolic screw cap (size No. 24) with polyvinyl liner which fits commercial narrow…

  • Baker-flex® Coated TLC Silica Gel Sheets

    Avantor - J.T.Baker®

    Ready-to-use plastic sheets, 50 x 200 mm or 200 x 200 mm, with absorbent coating, which is abrasion-resistant and highly uniform; are easily cut to desired size and allow sample fraction to be cut rather than scraped The silica gel and aluminum oxide sheets have coating approximately 200 microns…

  • Generic Bar Coded Polystyrene Microplates

    Corning

    Corning now offers a line of generic bar coded plates to better meet the demands of your screening needs. Labels applied to all 4 sides of the microplate to ensure usability regardless of scanner location Each microplate is specially treated to reduce the impact of static…

  • UV lamp 254 nm

    MilliporeSigma

    For Thin Layer Chromatography

  • Rectangular Developing Chambers

    General Glass Blowing

    The single most useful chamber for the TLC laboratory is a sturdy, molded-glass block of clear glass with flat surface walls, ground lip of uniform flatness, beveled inside and outside to remove any sharp edges. There is a raised ridge midway on the inside ends and bottom of the jar. Inside…

  • TLC Developing Tank

    Kimble

    Constructed of sturdy molded glass bricks Withstands regular use for many years The tank’s clear sides allow for visual inspection of TLC plates up to 20 x 20 cm size. The top of the tank is ground flat to match the lids and the edges are beveled to remove any sharp edges. The bottoms are…

  • 10 cm Developing Tank

    General Glass Blowing

    Flat ground top is beveled on the inner and outer rim Ground flat bottom for stability Holds two 10 x 10 cm plates or four 5 x 10 cm plates Thin-Line units allow for faster and more uniform solvent saturated atmosphere and therefore require less solvent. Inside dimensions: 12 x 6.4…

  • Rectangular Developing Tank

    General Glass Blowing

    Beveled inside and outside to remove any sharp edges Raised ridge midway on the inside ends and bottom for developing two 20 x 20 cm plates or the equivalent Inside dimensions: 27 x 7 x 26 cm Supplied with flat glass lid, 30 x 10 x 3 cm Molded glass block of clear glass with…

  • Latch-Lid Chromatotank Unit

    General Glass Blowing

    Clear glass sides allow unobstructed visual inspection of contents Tank is ground flat to match ground glass lid. Beveled inside and outside to remove any sharp edges. Holds two 20 x 20 cm plates or four 10 x 20 cm plates. Latching device holds the matching ground glass surfaces of the lid…

  • Chromatography TLC Sprayers

    Wilmad LabGlass

    When using thin layer or paper chromatography (TLC), these borosilicate glass atomizers are used for spraying chromogenic reagents. Complete unit consists of spray head, flask, and LG-1004 clamp. The air inlet tube has an opening to release pressure and stop spraying. All joints are Standard Taper 24/40.

  • Silica Gel F TLC Plates

    Miles Scientific (Analtech)

    Analtech’s flexible backed TLC plates offer the same exacting specifications as with the classic glass backed plates assuring batch-to-batch uniformity. Quality is controlled at each step in the manufacturing process — from incoming raw materials to outgoing packaging. Lighter…

  • Silica Gel GF UNIPLATES

    Miles Scientific (Analtech)

    Silica Gel G & GF UNIPLATES are the most widely used silica gel TLC plates. No organic substances are added to these products, thus making them compatible with sulfuric acid charring visualization. These plates are commonly scraped from the glass backing to isolate separated components for…

  • Sigma-Aldrich® TLC Plates silica gel matrix, L × W 20 cm × 20 cm

    MilliporeSigma

    Thin-layer chromatography (TLC) plates for adsorption, partition, and ion-exchange techniques. Six media choices with glass, polyester, and aluminum backings. Silica-based adsorbent layers in Sigma-Aldrich TLC plates incorporate a polymeric binder; highly purified silica gel plates incorporate a…

  • Aldrich® rectangular TLC developing tanks, complete L × H × W 17.5 cm × 11.0 cm …

    MilliporeSigma

    Legal Information Aldrich is a registered trademark of Sigma-Aldrich Co. LLC

  • Saturation Pads

    Miles Scientific (Analtech)

    Analtech offers improved saturation pads made from a textured paper. This provides greater surface to assist in rapid vapor saturation of a TLC chamber air space. The majority of TLC separations are performed under saturated conditions in large chambers to insure even solvent migration. Also, the…

  • TLC Plate

    GE Healthcare

    Partisil K6 60Å and K5 150Å TLC plates provide a choice of high-purity silica gels with polarity for normal phase separations. They provide enhanced performance compared to silica gel 'G' through better resolution, higher sensitivity and more durability. Moderate layer hardness makes possible…

  • TLC LuxPlate® Silica gel 60 F254

    MilliporeSigma

    Classic silica TLC plates are based on a combination of proven EMD Millipore silica gel 60 and the addition of a unique polymeric binder resulting in a very adherent and hard surface that will not crack or blister and even allow writing with a pensil on the surface without risk to damage the layer.

  • HPTLC silica gel 60

    MilliporeSigma

    HPTLC plates deliver fast and quantitative analysis of complex samples for manual or automated use. EMD Millipore’s HPTLC silica plates work three times faster than conventional TLC plates – and they’re more sensitive. The particle sizes range in HPTLC is between 4-8µm, which creates a smoother…

  • Baker-Flex'® Silica Gel Ib2-F 1 Pk

    Avantor - J.T.Baker®

    Flexible TLC Sheet for laboratory, research or manufacturing use Baker-flex™ polyester-backed sheets can be easily cut to remove a section of the sheet when you need to isolate a sample component of particular interest. Sheet Size: 2.5 x 7.5 cm Sheets/Package: 200 …

  • 10 cm Latch-Lid Chromatotank

    General Glass Blowing

    Requires less solvent to maintain equilibrium Gives excellent retention of solvent saturated chamber Holds two 10 x 10 cm plates The smaller cubic inch chamber allows for a faster and more uniform solvent-saturated atmosphere. Single molded tank has a flat ground top, beveled for…

  • Corning® High-Content Imaging Glass Bottom Microplates

    Corning

    High optical-quality glass bottom, black microplates are ideal for performing high-content cell-based assays using imaging systems. The glass bottom provides a flat and optically clear surface that reduces autofocus time, increases throughput and is ideal for cell growth. High optical quality…

  • TLC SILICA GEL 60 100 GLASS PLATES 2.5 X 7.5 CM

    MilliporeSigma

    EMDMilliporeclassical silica TLC plates are based on a combination of proven EMD Milliporesilica gel 60 and the addition of a unique polymeric binder resulting in a very adherent and hard surface that will not crack or blister and even allow writing with a pensil on the surface without risk to…

  • Baker-flex® Coated TLC Cellulose Sheets

    Avantor - J.T.Baker®

    Ready-to-use plastic sheets, 50 x 200 mm or 200 x 200 mm, with absorbent coating, which is abrasion-resistant and highly uniform; are easily cut to desired size and allow sample fraction to be cut rather than scraped The silica gel and aluminum oxide sheets have coating approximately 200 microns…

  • Silica Gel HLF UNIPLATES

    Miles Scientific (Analtech)

    These are the most rugged silica gel plates available. They not only ease handling and sample application, but also permit the use of up to 80% water in the developing solvent without loss of adherence of the adsorbent layer to the glass plate. Organic binder plates are recommended for all TLC…

  • Falcon® 4 Well TC-Treated In Vitro Fertilization (IVF) Plate, Individually…

    Corning

    Features Non-embryotoxic Non-pyrogenic Non-cytotoxic Tissue culture (TC)-treated for a consistent hydrophilic surface Sterilized by gamma irradiation (SAL 10-6) Packaged in peel-open, medical-style packaging Multi-unit bags have reseal tabs 17 x 11 mm IVF Four Well…

  • TLC-SILICA GEL 60 GF254 MEAN PARTICLE SIZE 15 MYM

    MilliporeSigma

    Standardized sorbents ensure reliable results every time. EMD Millipore’s broad spectrum meets all kinds of needs. In TLC, silica gel 60 sorbent is considered the most versatile. Our assortment of silica gel 60 features different grades with particle sizes ranging from 5-40 µ: silica with…

  • TLC Silica gel 60

    MilliporeSigma

    Classic silica TLC plates are based on a combination of proven EMD Millipore silica gel 60 and the addition of a unique polymeric binder resulting in a very adherent and hard surface that will not crack or blister and even allow writing with a pensil on the surface without risk to damage the layer.

  • Sigma-Aldrich® TLC Plates silica gel matrix

    MilliporeSigma

    material       polyester support, silica gel matrix feature       binder Polymeric, fluorescent indicator L × W       20 cm × 20 cm layer thickness       200 μm particle size…

Compare Tool

Select up to 3 products

Please Log In

Don't have an Account? Create one now.