Plates

TLC Plates, Plates

Compare Tool

Select up to 3 products

All Products

Plates TLC Plates

1 - 32 of 156
Sort
View
Show

Greiner

  • Cellulose plates (TLC and HPTLC)

    MilliporeSigma

    For analysis of polar substances The organic sorbent cellulose is particularly suitable for the separation of hydrophilic substances by partition chromatography. EMD Millipore cellulose plates include classical TLC grade or HPTLC plates for demanding high-performance separations: TLC…

  • Rectangular Developing Tank

    General Glass Blowing

    Beveled inside and outside to remove any sharp edges Raised ridge midway on the inside ends and bottom for developing two 20 x 20 cm plates or the equivalent Inside dimensions: 27 x 7 x 26 cm Supplied with flat glass lid, 30 x 10 x 3 cm Molded glass block of clear glass with…

  • TLC Developing Tank

    Kimble

    Constructed of sturdy molded glass bricks Withstands regular use for many years The tank’s clear sides allow for visual inspection of TLC plates up to 20 x 20 cm size. The top of the tank is ground flat to match the lids and the edges are beveled to remove any sharp edges. The bottoms are…

  • Thomas Glass Sprayer

    Thomas®

    Provides uniformly fine mist or spray, required for paper chromatographic determination Conveniently located vent permits instantaneous control of spray Borosilicate glass tube has permanently attached, molded phenolic screw cap (size No. 24) with polyvinyl liner which fits commercial narrow…

  • Aldrich® rectangular TLC developing tanks, complete L × H × W 17.5 cm × 11.0 cm …

    MilliporeSigma

    Legal Information Aldrich is a registered trademark of Sigma-Aldrich Co. LLC

  • TLC Reagent Sprayers

    Kimble

    Provides a uniform spray mist of visualization reagents for both thin layer and paper chromatography Borosilicate glass Handles all standard TLC spray reagents and most corrosive liquids Creates consistent spray patterns that are free of damaging droplets The connection between the sprayer…

  • Rectangular Developing Chambers

    General Glass Blowing

    The single most useful chamber for the TLC laboratory is a sturdy, molded-glass block of clear glass with flat surface walls, ground lip of uniform flatness, beveled inside and outside to remove any sharp edges. There is a raised ridge midway on the inside ends and bottom of the jar. Inside…

  • Baker-flex® Coated TLC Cellulose Sheets

    Avantor - J.T.Baker®

    Ready-to-use plastic sheets, 50 x 200 mm or 200 x 200 mm, with absorbent coating, which is abrasion-resistant and highly uniform; are easily cut to desired size and allow sample fraction to be cut rather than scraped The silica gel and aluminum oxide sheets have coating approximately 200 microns…

  • 10 cm Latch-Lid Chromatotank

    General Glass Blowing

    Requires less solvent to maintain equilibrium Gives excellent retention of solvent saturated chamber Holds two 10 x 10 cm plates The smaller cubic inch chamber allows for a faster and more uniform solvent-saturated atmosphere. Single molded tank has a flat ground top, beveled for…

  • TC-Treated Cell Culture Plates

    NEST Scientific USA

    Nest cell culture plates have round edges for better handling. Low profile, low-evaporation lid design assure uniform growth. Small feet on the bottom corners of each plate eliminate scraping of the microscope lens. Sterilized by E-beam High clarity, 100% virgin polystyrene Vacuum…

  • Glass-Backed Analytical TLC Plates

    Miles Scientific (Analtech)

    This TLC plate can be developed using purely organic, organic/aqueous, and purely aqueous mobile phases. Due to this these plates have been used in numerous applications in normal phase chromatography as well as reversed phase chromatography. Common applications include the analysis of active plant…

  • Latch-Lid Chromatotank Unit

    General Glass Blowing

    Clear glass sides allow unobstructed visual inspection of contents Tank is ground flat to match ground glass lid. Beveled inside and outside to remove any sharp edges. Holds two 20 x 20 cm plates or four 10 x 20 cm plates. Latching device holds the matching ground glass surfaces of the lid…

  • Chromatography TLC Sprayers

    Wilmad LabGlass

    When using thin layer or paper chromatography (TLC), these borosilicate glass atomizers are used for spraying chromogenic reagents. Complete unit consists of spray head, flask, and LG-1004 clamp. The air inlet tube has an opening to release pressure and stop spraying. All joints are Standard Taper 24/40.

  • 10 cm Developing Tank

    General Glass Blowing

    Flat ground top is beveled on the inner and outer rim Ground flat bottom for stability Holds two 10 x 10 cm plates or four 5 x 10 cm plates Thin-Line units allow for faster and more uniform solvent saturated atmosphere and therefore require less solvent. Inside dimensions: 12 x 6.4…

  • Baker-flex® Coated TLC Silica Gel Sheets

    Avantor - J.T.Baker®

    Ready-to-use plastic sheets, 50 x 200 mm or 200 x 200 mm, with absorbent coating, which is abrasion-resistant and highly uniform; are easily cut to desired size and allow sample fraction to be cut rather than scraped The silica gel and aluminum oxide sheets have coating approximately 200 microns…

  • Sigma-Aldrich® TLC Plates silica gel matrix

    MilliporeSigma

    material       polyester support, silica gel matrix feature       binder Polymeric, fluorescent indicator L × W       20 cm × 20 cm layer thickness       200 μm particle size…

  • Silica Gel F TLC Plates

    Miles Scientific (Analtech)

    Analtech’s flexible backed TLC plates offer the same exacting specifications as with the classic glass backed plates assuring batch-to-batch uniformity. Quality is controlled at each step in the manufacturing process — from incoming raw materials to outgoing packaging. Lighter…

  • HPTLC LICHROSPHER SILICA GEL 60 F254S 25 GLASS PLATES 20 X 10 CM

    MilliporeSigma

    Unique HPTLC Lichrospher® plates are the first thin layer chromatography plates based on spherical silica particles. They offer the ultimate in thin layer chromatography performance and speed enabling high throughput analysis of complex samples.

  • Silica Gel GF UNIPLATES

    Miles Scientific (Analtech)

    Silica Gel G & GF UNIPLATES are the most widely used silica gel TLC plates. No organic substances are added to these products, thus making them compatible with sulfuric acid charring visualization. These plates are commonly scraped from the glass backing to isolate separated components for…

  • TLC Silica gel 60 F254

    MilliporeSigma

    Classic silica TLC plates are based on a combination of proven EMD Millipore silica gel 60 and the addition of a unique polymeric binder resulting in a very adherent and hard surface that will not crack or blister and even allow writing with a pensil on the surface without risk to damage the layer.

  • UV lamp 254 nm

    MilliporeSigma

    For Thin Layer Chromatography

  • TLC Cellulose

    MilliporeSigma

    These cellulose plates are used to analyze polar substances. An organic sorbent, cellulose is perfect for separating hydrophilic substances by partition chromatography. Typical applications include the analysis of amino acids, carbohydrates, and phosphates as well as nucleic acid and nucleic acid…

  • Saturation Pads

    Miles Scientific (Analtech)

    Analtech offers improved saturation pads made from a textured paper. This provides greater surface to assist in rapid vapor saturation of a TLC chamber air space. The majority of TLC separations are performed under saturated conditions in large chambers to insure even solvent migration. Also, the…

  • Glass-Backed HPTLC Plates

    Miles Scientific (Analtech)

    High Performance UNIPLATES provide high resolution separations in less than five minutes with migration distances as little as 5 to 7 cm. These plates are prepared with high efficiency silica gel having a 10 micron average particle diameter and narrow particle size distribution. The adosrbent…

  • TLC SILICA GEL 60 RP-18 F254S 25 GLASS PLATES 5 X 10 CM

    MilliporeSigma

    RP modified plates serve two purposes: act as a pilot method for HPLC and allow to choose various solvent system for special separations. RP-modified silica layers from EMD Millipore are well suited for many separation challenges that unmodified silica cannot overcome. These layers use aqueous…

  • TLC Silice gel 60 NH2 F254s

    MilliporeSigma

    Our NH2, CN and DIOL -modified silica sorbents are less polar then conventional silica phases, making them ideal for separating hydrophilic or charged substances. Our moderately polar cyano- and diol-modified silica plates can be used for both normal phase and reversed phase systems. An…

  • TLC Silica gel 60 RP-2

    MilliporeSigma

    RP modified plates serve two purposes: act as a pilot method for HPLC and allow to choose various solvent system for special separations. RP-modified silica layers from EMD Millipore are well suited for many separation challenges that unmodified silica cannot overcome. These layers use aqueous…

  • Sigma-Aldrich® TLC Plates silica gel matrix, L × W 20 cm × 20 cm

    MilliporeSigma

    Thin-layer chromatography (TLC) plates for adsorption, partition, and ion-exchange techniques. Six media choices with glass, polyester, and aluminum backings. Silica-based adsorbent layers in Sigma-Aldrich TLC plates incorporate a polymeric binder; highly purified silica gel plates incorporate a…

  • TLC Silica gel 60

    MilliporeSigma

    Classic silica TLC plates are based on a combination of proven EMD Millipore silica gel 60 and the addition of a unique polymeric binder resulting in a very adherent and hard surface that will not crack or blister and even allow writing with a pensil on the surface without risk to damage the layer.

  • Baker-flex® Coated TLC Aluminum Oxide Sheets

    Avantor - J.T.Baker®

    Ready-to-use plastic sheets, 50 x 200 mm or 200 x 200 mm, with absorbent coating, which is abrasion-resistant and highly uniform; are easily cut to desired size and allow sample fraction to be cut rather than scraped The silica gel and aluminum oxide sheets have coating approximately 200 microns…

  • HPTLC Silica gel 60 F254 GLP

    MilliporeSigma

    These plates feature individual laser coding for GLP applications. Designed for GLP applications, the tops of each of these plates bear an item, batch, and individual plate number. As a result, lab professionals can easily record and archive every plate they use. Based on proven EMD Millipore…

  • HPTLC SILICA GEL 60 RP-2 F254S 25 GLASS PLATES 10 X 10 CM

    MilliporeSigma

    RP modified plates serve two purposes: act as a pilot method for HPLC and allow to choose various solvent system for special separations. RP-modified silica layers from EMD Milliporeare well suited for many separation challenges that unmodified silica cannot overcome. These layers use aqueous…

Compare Tool

Select up to 3 products

Please Log In

Don't have an Account? Create one now.