Rod End Connector (2824E29)
Holds 13 mm rods firmly at a 90° angle. Superior holding power for semi-permanent installations.
S-Connector (2824E33)
Clamps lab frame rods at 90° angle. Twin angled screws allow independent rod adjustment and easy access. Nickel plated cast zinc construction.
Hook Connector (2824E36)
Easily adjust rods with one hand.
Channel Connector (2824E39)
Special connector to fasten lab frames to steel channels, such as used in fume hoods. Stepped locating surface self-centers in channel. Position adjusts easily even while rods are mounted.
Multi Rod Connector (2824E43)
Oval center hole allows close connection of rods. Four 13 mm through holes allow for a variety of configurations.
Lab Frame Foot (2824E46)
Secure rod to counter tops, floors or walls with three included screws for solid lab frame setups.
End-to-End Connector (2824E49)
Extend the length of lab frame rods by joining end-to-end. Precisely bored hole for 13 mm rods makes solid connections with minimum horizontal movement. Solid aluminum construction adds strength and corrosion resistance.
Horizontal Mounting Bars with Coupler (2824E56 to E66)
13 mm aluminum rods have threaded end with locknut for direct installation into channel. Comes with channel coupler for use in both regular and short form steel channels.
Shelf Grip Support (2824E68)
Aluminum bracket has 43 mm clamp opening and firmly fastens rods to shelf at a depth of 50 mm. 13 mm rods may be inserted into holes with thumbscrew allowing vertical or horizontal rod positioning. Figure above illustrates one possible setup. Rods not included.
Wrench (2824E69)
Wrench for adjusting lab frame connectors